Discussion
Home ‣ Mechanical Engineering ‣ Automobile Engineering Comments
- Question
The lower cylindrical portion of the piston which improves piston cooling performance is called
Options- A. piston crown
- B. connecting rod
- C. piston pin boss
- D. piston skirt
- Correct Answer
- piston skirt
- 1. The main characteristics of a maintenance-free (MF) battery is that
Options- A. a maintenance-free battery requires little maintenance during normal use and it is sufficient to add water instead of an electrolyte containing sulphuric acid
- B. a maintenance-free battery has a relatively short shelf life when compared with standard batteries
- C. since it is sealed, the water in a maintenance-free battery is not lost through evaporation thus accordingly it is not necessary to top up the cells with water
- D. recharging of a maintenance-free battery is neither required nor possible Discuss
- 2. During suction stroke, the inside pressure of cylinder is
Options- A. more than the atmospheric pressure
- B. less than the atmospheric pressure
- C. equal to the atmospheric pressure
- D. none of these Discuss
- 3. The auto ignition in a spark ignition engine means
Options- A. automatic ignition of the charge at the end of compression
- B. ignition induced by the passage of a spark
- C. ignition of the charge before the passage of flame front
- D. ignition induced to supplement the process of normal combustion Discuss
- 4. The damper fluid leakage typically occur from
Options- A. upper damper mounting
- B. bottom of damper
- C. clearance between inner and outer tubes of damper
- D. coil spring mounting Discuss
- 5. The included angle is the sum of the
Options- A. camber and castor
- B. castor and S.A.I
- C. camber and S.A.I.
- D. camber and toe-in Discuss
- 6. The fuel pump of a programmed fuel injection (PFI) system operate for two seconds when the ignition is turned to the start position to
Options- A. enable the pump's fault-diagnosis function to operate
- B. warm up and lubricate the pump
- C. supply a large amount of fuel and thereby create a choke effect
- D. pressurise the fuel system before the engine is started Discuss
- 7. In petrol engines, during suction stroke, __________ is drawn in the cylinder
Options- A. air and fuel
- B. only fuel
- C. only air
- D. none of these Discuss
- 8. Which of the following parameter can be adjusted by modifying the tie-rod attachment length?
Options- A. Camber
- B. Caster
- C. Toe
- D. Steering gear ratio Discuss
- 9. The cam shaft in an engine is always mounted
Options- A. parallel to the crankshaft
- B. perpendicular to the crankshaft
- C. inclined to the crankshaft
- D. none of these Discuss
- 10. For the same maximum pressure and temperature
Options- A. Diesel cycle is more efficient than Otto cycle
- B. Otto cycle is more efficient than Diesel cycle
- C. both Otto cycle and Diesel cycle are equally efficient
- D. none of the above Discuss
Automobile Engineering problems
Search Results
Correct Answer: since it is sealed, the water in a maintenance-free battery is not lost through evaporation thus accordingly it is not necessary to top up the cells with water
Correct Answer: less than the atmospheric pressure
Correct Answer: ignition of the charge before the passage of flame front
Correct Answer: clearance between inner and outer tubes of damper
Correct Answer: camber and S.A.I.
Correct Answer: pressurise the fuel system before the engine is started
Correct Answer: air and fuel
Correct Answer: Toe
Correct Answer: parallel to the crankshaft
Correct Answer: Diesel cycle is more efficient than Otto cycle
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.