logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Automobile Engineering Comments

  • Question
  • The damper fluid leakage typically occur from


  • Options
  • A. upper damper mounting
  • B. bottom of damper
  • C. clearance between inner and outer tubes of damper
  • D. coil spring mounting

  • Correct Answer
  • clearance between inner and outer tubes of damper 


  • Automobile Engineering problems


    Search Results


    • 1. The included angle is the sum of the

    • Options
    • A. camber and castor
    • B. castor and S.A.I
    • C. camber and S.A.I.
    • D. camber and toe-in
    • Discuss
    • 2. The most effective method of controlling S.I. engine exhaust emission is by

    • Options
    • A. recirculating exhaust
    • B. using catalytic converter
    • C. using some additives in the fuel
    • D. none of these
    • Discuss
    • 3. The discharged lead-acid battery has on its plates

    • Options
    • A. lead peroxide (PbO2)
    • B. spongy lead (Pb)
    • C. lead sulphate (PbSO4)
    • D. sulphuric acid (H2SO4)
    • Discuss
    • 4. An under-inflated tyre will wear the tread most

    • Options
    • A. near the centre
    • B. near the edges
    • C. in the lateral direction
    • D. in the cross direction
    • Discuss
    • 5. The rigid suspension is beneficial when

    • Options
    • A. it is desired to reduce the unsprung mass
    • B. it is desired to have more flexibility in design
    • C. it is desired to improve tyre-to-ground contact characteristics
    • D. large changes in load make it necessary to have a large suspension stroke
    • Discuss
    • 6. The auto ignition in a spark ignition engine means

    • Options
    • A. automatic ignition of the charge at the end of compression
    • B. ignition induced by the passage of a spark
    • C. ignition of the charge before the passage of flame front
    • D. ignition induced to supplement the process of normal combustion
    • Discuss
    • 7. During suction stroke, the inside pressure of cylinder is

    • Options
    • A. more than the atmospheric pressure
    • B. less than the atmospheric pressure
    • C. equal to the atmospheric pressure
    • D. none of these
    • Discuss
    • 8. The main characteristics of a maintenance-free (MF) battery is that

    • Options
    • A. a maintenance-free battery requires little maintenance during normal use and it is sufficient to add water instead of an electrolyte containing sulphuric acid
    • B. a maintenance-free battery has a relatively short shelf life when compared with standard batteries
    • C. since it is sealed, the water in a maintenance-free battery is not lost through evaporation thus accordingly it is not necessary to top up the cells with water
    • D. recharging of a maintenance-free battery is neither required nor possible
    • Discuss
    • 9. The lower cylindrical portion of the piston which improves piston cooling performance is called

    • Options
    • A. piston crown
    • B. connecting rod
    • C. piston pin boss
    • D. piston skirt
    • Discuss
    • 10. The fuel pump of a programmed fuel injection (PFI) system operate for two seconds when the ignition is turned to the start position to

    • Options
    • A. enable the pump's fault-diagnosis function to operate
    • B. warm up and lubricate the pump
    • C. supply a large amount of fuel and thereby create a choke effect
    • D. pressurise the fuel system before the engine is started
    • Discuss


    Comments

    There are no comments.

Enter a new Comment