Discussion
Home ‣ Mechanical Engineering ‣ Automobile Engineering Comments
- Question
In vehicles with tilt steering, the steering column is pivoted in
Options- A. upper bracket
- B. lower bracket
- C. tilt bracket
- D. steering yoke joint
- Correct Answer
- lower bracket
- 1. A four-cylinder engine has a capacity of 2.4 litres. The swept volume of one cylinder is
Options- A. 400 cm3
- B. 600 cm3
- C. 1200 cm3
- D. 2400 cm3 Discuss
- 2. The sequence in which the force is transmitted through a brake system when the brake pedal is depressed is
Options- A. brake pedal - master cylinder - brake lines - vacuum servo mechanism - brake pads
- B. brake pedal - vacuum servo mechanism - master cylinder - brake lines - brake pads
- C. brake pedal - master cylinder - vacuum servo mechanism - brake lines - brake pads
- D. brake pedal - brake lines - vacuum servo mechanism - master cylinder - brake pads Discuss
- 3. The process of removing the burnt gases from the engine cylinder by the fresh charge coming into the engine cylinder from the crank-case, is known as
Options- A. cleaning
- B. priming
- C. scavenging
- D. detonation Discuss
- 4. Free pedal play in car clutches is about
Options- A. 15 mm
- B. 25 mm
- C. 40mm
- D. 60 mm Discuss
- 5. The parking brakes employed in vehicles are operated
Options- A. mechanically
- B. hydraulically
- C. pneumatically
- D. none of these Discuss
- 6. Thinner is added to the paint in order to
Options- A. make pigments and resin mix easily
- B. make paint film hard
- C. optimise its viscosity
- D. none of these Discuss
- 7. The device for smoothening out the power impulses from the engine is called
Options- A. clutch
- B. differential
- C. flywheel
- D. torque converter Discuss
- 8. An imbalance wheel during vehicle operation
Options- A. makes large noise when its heavy point hits the road surface
- B. deflects in the vehicle's longitudinal direction
- C. bounces vertically or deflects from side to side (as seen from front or rear)
- D. creates a standing wave Discuss
- 9. The temperature indicating instrument in vehicles indicates the temperature of
Options- A. engine piston
- B. engine cylinder
- C. lubricating oil
- D. jacket cooling water Discuss
- 10. The main function of an exhaust muffler is the
Options- A. optimisation of exhaust efficiency
- B. reduction of exhaust noise
- C. reduction of nitrogen oxide in the exhaust gases
- D. reduction of the exhaust gas volume Discuss
Automobile Engineering problems
Search Results
Correct Answer: 600 cm3
Correct Answer: brake pedal - vacuum servo mechanism - master cylinder - brake lines - brake pads
Correct Answer: scavenging
Correct Answer: 25 mm
Correct Answer: mechanically
Correct Answer: optimise its viscosity
Correct Answer: flywheel
Correct Answer: bounces vertically or deflects from side to side (as seen from front or rear)
Correct Answer: jacket cooling water
Correct Answer: reduction of exhaust noise
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.