Discussion
Home ‣ Mechanical Engineering ‣ Automobile Engineering Comments
- Question
The starting system includes
Options- A. a battery, a starter, and an ignition switch
- B. a battery, a distributor, and an ignition switch
- C. a battery, a starter, and a distributor
- D. a distributor, a starter, and an ignition switch
- Correct Answer
- a battery, a starter, and an ignition switch
- 1. In aluminium cylinder blocks, the cylinder liners are made of
Options- A. aluminium
- B. ceramic
- C. brass
- D. cast iron Discuss
- 2. The gradient resistance to a vehicle having a mass of 980 kg moving on an incline of 10° is
Options- A. 1.6694 N
- B. 16.694 N
- C. 166.94 N
- D. 1669.4 N Discuss
- 3. The purpose of a thermostat in an engine cooling system is to
Options- A. prevent the coolant from boiling
- B. allow the engine to warm up quickly
- C. indicate the coolant temperature
- D. pressurise the system to raise the boiling point Discuss
- 4. The ignition coil is used to
Options- A. step up current
- B. step down current
- C. step up voltage
- D. step down voltage Discuss
- 5. The purpose of a balancer shaft is to
Options- A. balance the timing in the movement of the two groups of pistons
- B. increase inertia force of the rotating crankshaft
- C. reduce vibrations caused by the crankshaft rotation
- D. adjust the timing of the intake and exhaust valve openings Discuss
- 6. The frequency of flashing of light per minute in a direction (side turn) indicator is about
Options- A. 9
- B. 90
- C. 900
- D. 9000 Discuss
- 7. The maximum torque multiplication ratio in a torque converter is about
Options- A. 2.5
- B. 10
- C. 25
- D. 40 Discuss
- 8. The function of a carburettor is to control the amount and ratio of air-fuel mixture.
Options- A. True
- B. False Discuss
- 9. The heat transfer from coolant to air in the radiator of an automobile engine takes place by
Options- A. radiation only
- B. convention only
- C. convection and radiation
- D. conduction, convection and radiation Discuss
- 10. The connecting rod is attached to the piston by the
Options- A. cap bolt
- B. piston pin
- C. cap roller bearing
- D. rod cap Discuss
Automobile Engineering problems
Search Results
Correct Answer: cast iron
Correct Answer: 1669.4 N
Correct Answer: allow the engine to warm up quickly
Correct Answer: step up voltage
Correct Answer: reduce vibrations caused by the crankshaft rotation
Correct Answer: 90
Correct Answer: 2.5
Correct Answer: True
Correct Answer: convection and radiation
Correct Answer: piston pin
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.