Discussion
Home ‣ Mechanical Engineering ‣ Workshop Technology Comments
- Question
In a simple die
Options- A. two or more operations are performed simultaneously at the single stroke of the ram
- B. two or more cutting operations are performed at one station of the press in every stroke of the ram
- C. both cutting and non-cutting operations are performed at one station of the press in every stroke of the ram
- D. none of the above
- Correct Answer
- none of the above
- 1. The operation of producing cup shaped parts from flat sheet metal blanks by bending and plastic flow of metal, is known as
Options- A. drawing
- B. squeezing
- C. coining
- D. planishing Discuss
- 2. The punch and die set up is __________ for punching and piercing operation.
Options- A. similar
- B. different Discuss
- 3. Projection welding is a
Options- A. continuous spot welding process
- B. multi-spot welding process
- C. arc welding process
- D. process used for joining round bars Discuss
- 4. When the dimension is expressed as
, then the tolerance is
Options- A. 0.035 mm
- B. 0.025 mm
- C. 0.01 mm
- D. 0.06 mm Discuss
- 5. The algebraic difference between the maximum limit and the basic size is called
Options- A. actual deviation
- B. upper deviation
- C. lower deviation
- D. fundamental deviation Discuss
- 6. The instrument used to measure external and internal diameter of shafts, thickness of parts and depth of holes, is
Options- A. outside micrometer
- B. inside micrometer
- C. depth gauge micrometer
- D. vernier caliper Discuss
- 7. The adhesiveness is the property of a sand due to which
Options- A. it evolves a great amount of steam and other gases
- B. the sand grains stick together
- C. it cling to the sides of a moulding box
- D. none of these Discuss
- 8. For gas welding, the pressure desired at the welding torch for oxygen is
Options- A. 7 to 103 kN/m2
- B. 70 to 280 kN/m2
- C. 280 to 560 kN/m2
- D. 560 to 840 kN/m2 Discuss
- 9. The brass and bronze are welded by __________ flame.
Options- A. neutral
- B. oxidising
- C. carburising
- D. all of these Discuss
- 10. When more volume of acetylene and less volume of oxygen is supplied, then a __________ flame is obtained.
Options- A. neutral
- B. oxidising
- C. carburising Discuss
Workshop Technology problems
Search Results
Correct Answer: drawing
Correct Answer: similar
Correct Answer: multi-spot welding process
Correct Answer: 0.06 mm
Correct Answer: upper deviation
Correct Answer: vernier caliper
Correct Answer: it cling to the sides of a moulding box
Correct Answer: 70 to 280 kN/m2
Correct Answer: oxidising
Correct Answer: carburising
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.