logo

CuriousTab

CuriousTab

Discussion

Home ‣ Mechanical Engineering ‣ Workshop Technology Comments
  • Question

  • The algebraic difference between the maximum limit and the basic size is called


  • Options
  • A. actual deviation
  • B. upper deviation
  • C. lower deviation
  • D. fundamental deviation

  • Correct Answer
  • upper deviation 

    • Workshop Technology problems

    Search Results

    • 1. For smoothing and cleaning out depressions in the mould, a __________ is used.

    • Options
    • A. slick
    • B. lifter
    • C. swab
    • D. gagger
      • Discuss
    • 2. Seam weiding is a

    • Options
    • A. continuous spot welding process
    • B. multi-spot welding process
    • C. arc welding process
    • D. process used for joining round bars
      • Discuss
    • 3. Fin is a casting defect which is due to thin projections of metal not intended as a part of casting.

    • Options
    • A. Correct
    • B. Incorrect
      • Discuss
    • 4. In a four high rolling mill, the diameter of backing up rolls is __________ the diameter of working rolls.

    • Options
    • A. equal to
    • B. smaller than
    • C. larger than
      • Discuss
    • 5. The dowels are

    • Options
    • A. wooden nails
    • B. box nails
    • C. wire nails
    • D. none of these
      • Discuss
    • 6. When the dimension is expressed as , then the tolerance is

    • Options
    • A. 0.035 mm
    • B. 0.025 mm
    • C. 0.01 mm
    • D. 0.06 mm
      • Discuss
    • 7. Projection welding is a

    • Options
    • A. continuous spot welding process
    • B. multi-spot welding process
    • C. arc welding process
    • D. process used for joining round bars
      • Discuss
    • 8. The punch and die set up is __________ for punching and piercing operation.

    • Options
    • A. similar
    • B. different
      • Discuss
    • 9. The operation of producing cup shaped parts from flat sheet metal blanks by bending and plastic flow of metal, is known as

    • Options
    • A. drawing
    • B. squeezing
    • C. coining
    • D. planishing
      • Discuss
    • 10. In a simple die

    • Options
    • A. two or more operations are performed simultaneously at the single stroke of the ram
    • B. two or more cutting operations are performed at one station of the press in every stroke of the ram
    • C. both cutting and non-cutting operations are performed at one station of the press in every stroke of the ram
    • D. none of the above
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.