Discussion
Home ‣ Mechanical Engineering ‣ Workshop Technology Comments
- Question
Which of the following statement is wrong?
Options- A. The hot chamber die casting machine is used for casting zinc, tin, lead and other low melting alloys.
- B. The cold chamber die casting machine is used for casting aluminium, magnesium, copper base alloys and other high melting alloys.
- C. The castings produced by centrifugal casting method have open and coarse grained structure.
- D. all of the above
- Correct Answer
- The castings produced by centrifugal casting method have open and coarse grained structure.
- 1. The process used to improve fatigue resistance of the metal by setting up compressive stresses in its surface, is known as
Options- A. hot piercing
- B. extrusion
- C. cold peening
- D. cold heading Discuss
- 2. The vertical welding do not require plate edge preparation upto 16 mm thickness.
Options- A. Correct
- B. Incorrect Discuss
- 3. Green sand is a mixture of
Options- A. 30% sand and 70% clay
- B. 50% sand and 50% clay
- C. 70% sand and 30% clay
- D. 90% sand and 10% clay Discuss
- 4. Cast iron and steel pipes are produced by
Options- A. slush casting
- B. investment casting
- C. true centrifugal casting
- D. die casting Discuss
- 5. The metal extrusion process is generally used for producing
Options- A. uniform solid sections
- B. uniform hollow sections
- C. uniform solid and hollow sections
- D. varying solid and hollow sections Discuss
- 6. The welding process used to join the ends of two pipes of uniform cross-section, is
Options- A. spot welding
- B. seam welding
- C. projection welding
- D. upset butt welding Discuss
- 7. For arc welding
Options- A. alternating current with high frequency is used
- B. alternating current with low frequency is used
- C. direct current is used
- D. any one of these Discuss
- 8. The dowels are
Options- A. wooden nails
- B. box nails
- C. wire nails
- D. none of these Discuss
- 9. In a four high rolling mill, the diameter of backing up rolls is __________ the diameter of working rolls.
Options- A. equal to
- B. smaller than
- C. larger than Discuss
- 10. Fin is a casting defect which is due to thin projections of metal not intended as a part of casting.
Options- A. Correct
- B. Incorrect Discuss
Workshop Technology problems
Search Results
Correct Answer: cold peening
Correct Answer: Correct
Correct Answer: 70% sand and 30% clay
Correct Answer: true centrifugal casting
Correct Answer: uniform solid and hollow sections
Correct Answer: upset butt welding
Correct Answer: direct current is used
Correct Answer: wooden nails
Correct Answer: larger than
Correct Answer: Correct
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.