Discussion
Home ‣ Mechanical Engineering ‣ Workshop Technology Comments
- Question
The acetylene cylinder is usually painted with
Options- A. black colour
- B. white colour
- C. maroon colour
- D. yellow colour
- Correct Answer
- maroon colour
- 1. The welding process used in joining mild steel shanks to high speed drills, is
Options- A. spot welding
- B. seam welding
- C. flash butt welding
- D. upset butt welding Discuss
- 2. Swab is used for
Options- A. smoothing and cleaning out depressions in the mould
- B. cleaning the moulding sand
- C. moistening the sand around the edge before removing pattern
- D. reinforcement of sand in the top part of the moulding box Discuss
- 3. The hot working of metals is carried out
Options- A. at the recrystallisation temperature
- B. below the recrystallisation temperature
- C. above the recrystallisation temperature
- D. at any temperature Discuss
- 4. Hot piercing is extensively used for making bolts and nuts.
Options- A. Yes
- B. No Discuss
- 5. Cold working distorts grain structure and does not provide an appreciable reduction in size.
Options- A. Correct
- B. Incorrect Discuss
- 6. The metal patterns as compared to wooden patterns require less
Options- A. shrinkage allowance
- B. machining allowance
- C. draft allowance
- D. distortion allowance Discuss
- 7. If an aluminium pattern made from a wooden master pattern is to be used for grey iron castings, then the shrinkage allowance allowed on the wooden pattern should be
Options- A. 10 mm/m
- B. 16 mm/m
- C. 20 mm/m
- D. 26 mm/m Discuss
- 8. The diaphragm moulding machine is used to
Options- A. ram the sand harder at the pattern face with decreasing hardness towards the back of the mould
- B. ram the sand harder at the back of the mould and softer on the pattern face
- C. produce uniform packing of sand in the mould
- D. give uniform sand hardness throughout the mould Discuss
- 9. The difference between the upper limit and lower limt of a dimension is called
Options- A. nominal size
- B. basic size
- C. actual size
- D. tolerance Discuss
- 10. When the molten metal is fed in the cavity of a metallic mould by gravity, the method of casting is known as
Options- A. die casting method
- B. slush casting method
- C. permanent mould casting method
- D. centrifugal casting method Discuss
Workshop Technology problems
Search Results
Correct Answer: flash butt welding
Correct Answer: moistening the sand around the edge before removing pattern
Correct Answer: above the recrystallisation temperature
Correct Answer: No
Correct Answer: Correct
Correct Answer: draft allowance
Correct Answer: 26 mm/m
Correct Answer: give uniform sand hardness throughout the mould
Correct Answer: tolerance
Correct Answer: permanent mould casting method
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.