Discussion
Home ‣ Mechanical Engineering ‣ Workshop Technology Comments
- Question
The operation of cutting of a flat sheet to the desired shape is called
Options- A. shearing
- B. piercing
- C. punching
- D. blanking
- Correct Answer
- shearing
- 1. In a gas welding of mild steel using an oxy-acetylene flame, the total amount of acetylene consumed is 10 litre. The oxygen consumption from the cylinder is
Options- A. 5 litre
- B. 10 litre
- C. 15 litre
- D. 20 litre Discuss
- 2. Which of the following welding method uses a pool of molten metal?
Options- A. Carbon arc welding
- B. Submerged arc welding
- C. TIG arc welding
- D. MIG arc welding Discuss
- 3. When a pattern is made in three parts, the top part, is known as a
Options- A. drag
- B. cheek
- C. cope
- D. none of these Discuss
- 4. In back-hand welding, the angle between the welding rod and the work is __________ as compared to fore-hand welding.
Options- A. same
- B. less
- C. more Discuss
- 5. In permanent mould casting method
Options- A. molten metal is poured in a metallic mould, retained in the mould long enough for the outer skin to solidify and finally mould is turned over to remove molten metal still in molten condition
- B. molten metal is poured and allowed to solidify while the mould is revolving
- C. molten metal is forced into mould under high pressure
- D. none of the above Discuss
- 6. The mode of deformation of the metal during spinning is
Options- A. bending
- B. stretching
- C. rolling and stretching
- D. bending and stretching Discuss
- 7. In TIG arc welding, the welding zone is shielded by an atmosphere of
Options- A. helium gas
- B. argon gas
- C. either (a) or (b)
- D. none of these Discuss
- 8. Cold working distorts grain structure and does not provide an appreciable reduction in size.
Options- A. Correct
- B. Incorrect Discuss
- 9. Hot piercing is extensively used for making bolts and nuts.
Options- A. Yes
- B. No Discuss
- 10. The hot working of metals is carried out
Options- A. at the recrystallisation temperature
- B. below the recrystallisation temperature
- C. above the recrystallisation temperature
- D. at any temperature Discuss
Workshop Technology problems
Search Results
Correct Answer: 10 litre
Correct Answer: Submerged arc welding
Correct Answer: cope
Correct Answer: same
Correct Answer: none of the above
Correct Answer: bending and stretching
Correct Answer: either (a) or (b)
Correct Answer: Correct
Correct Answer: No
Correct Answer: above the recrystallisation temperature
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.