Discussion
Home ‣ Mechanical Engineering ‣ Workshop Technology Comments
- Question
The purpose of a gate is to
Options- A. deliver molten metal into the mould cavity
- B. act as a reservoir for the molten metal
- C. feed the molten metal to the casting in order to compensate for the shrinkage
- D. deliver molten metal from pouring basin to gate
- Correct Answer
- deliver molten metal into the mould cavity
- 1. During drawing operation, the states of stress in cup would include
Options- A. compressive stress in the flange
- B. tensile stress in the wall
- C. both (a) and (b)
- D. none of these Discuss
- 2. When two pieces of different metals are to be welded by projection welding, then the projection should be made on the metal piece having __________ conductivity.
Options- A. lower
- B. higher Discuss
- 3. During cold working process
Options- A. grain structure is distorted
- B. strength and hardness of metal increases
- C. close dimensional tolerance can be maintained
- D. all of the above Discuss
- 4. The advantage of thermit welding is that
Options- A. all parts of the weld section are molten at the same time
- B. weld cools almost uniformly
- C. results in a minimum problem with internal residual stresses
- D. all of the above Discuss
- 5. A progressive limit gauge has
Options- A. 'Go' and 'Not go' member on the same side of the gauge
- B. separate 'Go' and 'Not go' members
- C. 'Go' member at one end and 'Not go' member at the other end
- D. none of the above Discuss
- 6. Riddle is used for
Options- A. smoothing and cleaning out depressions in the mould
- B. cleaning the moulding sand
- C. moistening the sand around the edge before removing pattern
- D. reinforcement of sand in the top part of moulding box Discuss
- 7. A basic hole is one whose
Options- A. lower deviation is zero
- B. upper deviation is zero
- C. lower and upper deviations are zero
- D. none of these Discuss
- 8. Which one of the following material will require the largest size of riser for the same size of casting?
Options- A. Aluminium
- B. Cast iron
- C. Steel
- D. Copper Discuss
- 9. The maximum flame temperature occurs
Options- A. at the outer cone
- B. at the inner cone
- C. between the outer and inner cone
- D. at the torch tip Discuss
- 10. Slick is used for repairing and finishing the mould.
Options- A. Correct
- B. Incorrect Discuss
Workshop Technology problems
Search Results
Correct Answer: both (a) and (b)
Correct Answer: higher
Correct Answer: all of the above
Correct Answer: all of the above
Correct Answer: 'Go' and 'Not go' member on the same side of the gauge
Correct Answer: cleaning the moulding sand
Correct Answer: lower deviation is zero
Correct Answer: Steel
Correct Answer: at the inner cone
Correct Answer: Correct
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.