Discussion
Home ‣ Mechanical Engineering ‣ Workshop Technology Comments
- Question
The advantage of thermit welding is that
Options- A. all parts of the weld section are molten at the same time
- B. weld cools almost uniformly
- C. results in a minimum problem with internal residual stresses
- D. all of the above
- Correct Answer
- all of the above
- 1. A progressive limit gauge has
Options- A. 'Go' and 'Not go' member on the same side of the gauge
- B. separate 'Go' and 'Not go' members
- C. 'Go' member at one end and 'Not go' member at the other end
- D. none of the above Discuss
- 2. The parts of circular cross-section which are symmetrical about the axis of rotation are made by
Options- A. hot forging
- B. hot spinning
- C. hot extrusion
- D. hot drawing Discuss
- 3. In a __________ , the molten metal is poured and allowed to solidify while the mould is revolving.
Options- A. die casting method
- B. slush casting method
- C. permanent mould casting method
- D. centrifugal casting method Discuss
- 4. A process used for making thin phosphate coating on steel is called parkerising.
Options- A. Correct
- B. Incorrect Discuss
- 5. A gimlet is a __________ tool.
Options- A. boring
- B. marking Discuss
- 6. During cold working process
Options- A. grain structure is distorted
- B. strength and hardness of metal increases
- C. close dimensional tolerance can be maintained
- D. all of the above Discuss
- 7. When two pieces of different metals are to be welded by projection welding, then the projection should be made on the metal piece having __________ conductivity.
Options- A. lower
- B. higher Discuss
- 8. During drawing operation, the states of stress in cup would include
Options- A. compressive stress in the flange
- B. tensile stress in the wall
- C. both (a) and (b)
- D. none of these Discuss
- 9. The purpose of a gate is to
Options- A. deliver molten metal into the mould cavity
- B. act as a reservoir for the molten metal
- C. feed the molten metal to the casting in order to compensate for the shrinkage
- D. deliver molten metal from pouring basin to gate Discuss
- 10. Riddle is used for
Options- A. smoothing and cleaning out depressions in the mould
- B. cleaning the moulding sand
- C. moistening the sand around the edge before removing pattern
- D. reinforcement of sand in the top part of moulding box Discuss
Workshop Technology problems
Search Results
Correct Answer: 'Go' and 'Not go' member on the same side of the gauge
Correct Answer: hot spinning
Correct Answer: centrifugal casting method
Correct Answer: Correct
Correct Answer: boring
Correct Answer: all of the above
Correct Answer: higher
Correct Answer: both (a) and (b)
Correct Answer: deliver molten metal into the mould cavity
Correct Answer: cleaning the moulding sand
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.