Discussion
Home ‣ Mechanical Engineering ‣ Workshop Technology Comments
- Question
In die casting, machining allowance is
Options- A. small
- B. large
- C. very large
- D. not provided
- Correct Answer
- not provided
- 1. During hot working of metals
Options- A. porosity of the metal is largely eliminated
- B. grain structure of the metal is refined
- C. mechanical properties are improved due to refinement of grains
- D. all of the above Discuss
- 2. The welding set up is said to have straight polarity, when
Options- A. work is connected to the positive terminal and the electrode holder to the negative terminal
- B. work is connected to the negative terminal and the electrode holder to the positive terminal
- C. work is connected to the positive terminal and the electrode holder is earthed
- D. work is connected to the negative terminal and the electrode holder is earthed Discuss
- 3. The material which can be best cut with oxygen cutting process is
Options- A. mild steel
- B. brass
- C. copper
- D. aluminium Discuss
- 4. When two metal pieces of different thicknesses are to be welded by projection welding, then the projections should be made on __________ metal piece.
Options- A. thinner
- B. thicker Discuss
- 5. In spot welding, the distance between the nearest edge of the plate and centre of weld should be equal to
Options- A. d
- B. 1.5 d
- C. 3 d
- D. 6 d Discuss
- 6. Thermit, used in thermit welding, is a mixture of
Options- A. charcoal and iron oxide
- B. charcoal and aluminium
- C. iron oxide and aluminium
- D. charcoal, iron oxide and aluminium Discuss
- 7. Which of the following material can be used for making patterns?
Options- A. Aluminium
- B. Wax
- C. Lead
- D. all of these Discuss
- 8. The teeth of hacksaw blade are bent
Options- A. towards right
- B. towards left
- C. alternately towards right and left and every third or fourth left straight
- D. may be bent in any direction Discuss
- 9. A moving mandrel is used in
Options- A. wiredrawing
- B. tube drawing
- C. metal cutting
- D. forging Discuss
- 10. For cutting brass, the hacksaw blade should have __________ teeth per 25 mm.
Options- A. 14
- B. 24
- C. 32
- D. 40 Discuss
Workshop Technology problems
Search Results
Correct Answer: all of the above
Correct Answer: work is connected to the positive terminal and the electrode holder to the negative terminal
Correct Answer: mild steel
Correct Answer: thicker
Correct Answer: 1.5 d
Correct Answer: iron oxide and aluminium
Correct Answer: all of these
Correct Answer: alternately towards right and left and every third or fourth left straight
Correct Answer: tube drawing
Correct Answer: 14
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.