Discussion
Home ‣ Mechanical Engineering ‣ Workshop Technology Comments
- Question
When two metal pieces of different thicknesses are to be welded by projection welding, then the projections should be made on __________ metal piece.
Options- A. thinner
- B. thicker
- Correct Answer
- thicker
- 1. In spot welding, the distance between the nearest edge of the plate and centre of weld should be equal to
Options- A. d
- B. 1.5 d
- C. 3 d
- D. 6 d Discuss
- 2. Which of the following statement is wrong?
Options- A. The angular clearance on dies varies from 0.5° to 1°.
- B. In drawing operation, the metal flows due to plasticity.
- C. In press operation, the size of the pierced hole is independent of the size of punch.
- D. none of the above Discuss
- 3. The upsetting is a process of
Options- A. increasing the cross-section of a bar
- B. reducing the cross-section of a bar
- C. joining the two surfaces of metal under pressure after heating
- D. bending of a bar Discuss
- 4. The binder commonly used in making oil sand, is
Options- A. clay-type binder
- B. organic-type binder
- C. inorganic-type binder
- D. any one of these Discuss
- 5. The electron beam welding can be carried out in
Options- A. open air
- B. a shielded gas environment
- C. vacuum
- D. a pressurised inert gas chamber Discuss
- 6. The material which can be best cut with oxygen cutting process is
Options- A. mild steel
- B. brass
- C. copper
- D. aluminium Discuss
- 7. The welding set up is said to have straight polarity, when
Options- A. work is connected to the positive terminal and the electrode holder to the negative terminal
- B. work is connected to the negative terminal and the electrode holder to the positive terminal
- C. work is connected to the positive terminal and the electrode holder is earthed
- D. work is connected to the negative terminal and the electrode holder is earthed Discuss
- 8. During hot working of metals
Options- A. porosity of the metal is largely eliminated
- B. grain structure of the metal is refined
- C. mechanical properties are improved due to refinement of grains
- D. all of the above Discuss
- 9. In die casting, machining allowance is
Options- A. small
- B. large
- C. very large
- D. not provided Discuss
- 10. Thermit, used in thermit welding, is a mixture of
Options- A. charcoal and iron oxide
- B. charcoal and aluminium
- C. iron oxide and aluminium
- D. charcoal, iron oxide and aluminium Discuss
Workshop Technology problems
Search Results
Correct Answer: 1.5 d
Correct Answer: none of the above
Correct Answer: increasing the cross-section of a bar
Correct Answer: organic-type binder
Correct Answer: vacuum
Correct Answer: mild steel
Correct Answer: work is connected to the positive terminal and the electrode holder to the negative terminal
Correct Answer: all of the above
Correct Answer: not provided
Correct Answer: iron oxide and aluminium
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.