Discussion
Home ‣ Mechanical Engineering ‣ Workshop Technology Comments
- Question
The drawing down is a process of __________ the cross-section of a bar.
Options- A. increasing
- B. reducing
- Correct Answer
- reducing
- 1. Which of the following statement is wrong?
Options- A. The mortise gauge has two scribing pins.
- B. The gouges are chisels with a hollow shaped blade.
- C. An auger is a planing tool
- D. all of these Discuss
- 2. An oxidising flame is obtained when equal volumes of oxygen and acetylene are supplied.
Options- A. True
- B. False Discuss
- 3. In sheet metal work, the cutting force on the tool can be reduced by
Options- A. grinding the cutting edges sharp
- B. increasing the hardness of tool
- C. providing shear on tool
- D. increasing the hardness of die Discuss
- 4. Tandem drawing of wires and tubes is necessary because
Options- A. it is not possible to reduce at one stage
- B. annealing is needed between stages
- C. accuracy in dimensions is not possible otherwise
- D. surface finish improves after every drawing stage Discuss
- 5. Shrinkage allowance is made by adding to external dimensions and subtracting from internal dimensions.
Options- A. Agree
- B. Disagree Discuss
- 6. During hot working of metals
Options- A. poor surface finish is produced
- B. scale is formed on the metal surface
- C. close tolerances can not be maintained
- D. all of these Discuss
- 7. A jolt machine is used to
Options- A. ram the sand harder at the pattern face with decreasing hardness towards the back of the mould
- B. ram the sand harder at the back of the mould and softer on the pattern face
- C. produce uniform sand hardness throughout the mould
- D. produce uniform packing of sand in the mould Discuss
- 8. Spot welding is used for welding
Options- A. lap joints in plates having 0.025 mm to 1.25 mm thickness
- B. lap joints in plates having thickness above 3 mm
- C. butt joints in plates having 0.025 mm to 1.25 mm thickness
- D. butt joints in plates having thickness above 3 mm Discuss
- 9. The directional solidification in casting can be improved by using
Options- A. chills and chaplets
- B. chills and padding
- C. chaplets and padding
- D. chills, chaplets and padding Discuss
- 10. In tungsten-inert gas arc welding, a __________ electrode is used.
Options- A. consumable
- B. non-consumable Discuss
Workshop Technology problems
Search Results
Correct Answer: An auger is a planing tool
Correct Answer: False
Correct Answer: grinding the cutting edges sharp
Correct Answer: annealing is needed between stages
Correct Answer: Agree
Correct Answer: all of these
Correct Answer: ram the sand harder at the pattern face with decreasing hardness towards the back of the mould
Correct Answer: lap joints in plates having 0.025 mm to 1.25 mm thickness
Correct Answer: chills and padding
Correct Answer: non-consumable
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.