Discussion
Home ‣ Mechanical Engineering ‣ Workshop Technology Comments
- Question
In sheet metal work, the cutting force on the tool can be reduced by
Options- A. grinding the cutting edges sharp
- B. increasing the hardness of tool
- C. providing shear on tool
- D. increasing the hardness of die
- Correct Answer
- grinding the cutting edges sharp
- 1. Tandem drawing of wires and tubes is necessary because
Options- A. it is not possible to reduce at one stage
- B. annealing is needed between stages
- C. accuracy in dimensions is not possible otherwise
- D. surface finish improves after every drawing stage Discuss
- 2. Shrinkage allowance is made by adding to external dimensions and subtracting from internal dimensions.
Options- A. Agree
- B. Disagree Discuss
- 3. For welding plates of thickness less than 5 mm, its edges
Options- A. do not require bevelling
- B. should be bevelled to a single-V or U-groove
- C. should have a double-V or U-groove on one side
- D. should have a double-V or U-groove on both sides Discuss
- 4. Cores are used to
Options- A. form internal cavities in the casting
- B. improve mould surface
- C. form a part of a green sand mould
- D. all of these Discuss
- 5. In electric resistance welding, voltage required for heating is
Options- A. 1 to 5 volts
- B. 6 to 10 volts
- C. 11 to 20 volts
- D. 50 to 100 volts Discuss
- 6. An oxidising flame is obtained when equal volumes of oxygen and acetylene are supplied.
Options- A. True
- B. False Discuss
- 7. Which of the following statement is wrong?
Options- A. The mortise gauge has two scribing pins.
- B. The gouges are chisels with a hollow shaped blade.
- C. An auger is a planing tool
- D. all of these Discuss
- 8. The drawing down is a process of __________ the cross-section of a bar.
Options- A. increasing
- B. reducing Discuss
- 9. During hot working of metals
Options- A. poor surface finish is produced
- B. scale is formed on the metal surface
- C. close tolerances can not be maintained
- D. all of these Discuss
- 10. A jolt machine is used to
Options- A. ram the sand harder at the pattern face with decreasing hardness towards the back of the mould
- B. ram the sand harder at the back of the mould and softer on the pattern face
- C. produce uniform sand hardness throughout the mould
- D. produce uniform packing of sand in the mould Discuss
Workshop Technology problems
Search Results
Correct Answer: annealing is needed between stages
Correct Answer: Agree
Correct Answer: do not require bevelling
Correct Answer: all of these
Correct Answer: 6 to 10 volts
Correct Answer: False
Correct Answer: An auger is a planing tool
Correct Answer: reducing
Correct Answer: all of these
Correct Answer: ram the sand harder at the pattern face with decreasing hardness towards the back of the mould
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.