Discussion
Home ‣ Mechanical Engineering ‣ Engineering Materials Comments
- Question
The process which improves the machinability of steels, but lowers the hardness and tensile strength, is
Options- A. normalising
- B. full annealing
- C. process annealing
- D. spheroidising
- Correct Answer
- spheroidising
- 1. The malleability is the property of a material due to which it can be rolled or hammered into thin sheets.
Options- A. Agree
- B. Disagree Discuss
- 2. The process used for relieving the internal stresses previously set up in the Metal and for increasing the machinability of steel, is
Options- A. normalising
- B. full annealing
- C. process annealing
- D. spheroidising Discuss
- 3. Thermosetting plastics are those materials which
Options- A. are formed into shape under heat and pressure and results in a permanently hard product
- B. do not become hard with the application of heat and pressure and no chemical change occurs
- C. are flexible and can withstand considerable wear under suitable conditions
- D. are used as a friction lining for clutches and brakes Discuss
- 4. The temperature point at which the change ends on heating the steel is called
Options- A. lower critical point
- B. upper critical point
- C. point of recalescence
- D. point of decalescence Discuss
- 5. Phosphor bronze has
Options- A. high resistance to corrosion
- B. good wearing qualities and high elasticity
- C. valuable cold working property
- D. all of these Discuss
- 6. Silicon in cast iron
Options- A. makes the iron soft and easily machinable
- B. increases hardness and brittleness
- C. makes the iron white and hard
- D. aids fusibility and fluidity Discuss
- 7. The delta-iron possesses a body centred cubic space lattice.
Options- A. Correct
- B. Incorrect Discuss
- 8. Which of the following solids are malleable and ductile?
Options- A. Ionic solids
- B. Covalent solids
- C. Metallic solids
- D. none of these Discuss
- 9. A carbon steel having Brinell hardness number 100 should have ultimate tensile strength closer to
Options- A. 100 N/mm2
- B. 200 N/mm2
- C. 350 N/mm2
- D. 1000 N/mm2 Discuss
- 10. The nuts and bolts are made from silicon steel.
Options- A. Correct
- B. Incorrect Discuss
Engineering Materials problems
Search Results
Correct Answer: Agree
Correct Answer: process annealing
Correct Answer: are formed into shape under heat and pressure and results in a permanently hard product
Correct Answer: upper critical point
Correct Answer: good wearing qualities and high elasticity
Correct Answer: makes the iron soft and easily machinable
Correct Answer: Correct
Correct Answer: Metallic solids
Correct Answer: 350 N/mm2
Correct Answer: Incorrect
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.