Discussion
Home ‣ Mechanical Engineering ‣ Engineering Materials Comments
- Question
For the pipe fitting like elbow, tee, union etc., which of the following is preferred?
Options- A. Pig iron
- B. Malleable iron
- C. Spheroidal graphite cast iron
- D. High carbon steel
- Correct Answer
- Malleable iron
- 1. The ductility is the property of a material due to which it
Options- A. can be drawn into wires
- B. breaks with little permanent distortion
- C. can be rolled or hammered into thin sheets
- D. can resist fracture due to high impact loads Discuss
- 2. A steel with 0.8% carbon is known as
Options- A. eutectoid steel
- B. hyper-eutectoid steel
- C. hypo-eutectiod steel
- D. none of these Discuss
- 3. Iron-carbon alloys containing 4.3% carbon are known as hypo-eutectic cast irons.
Options- A. Correct
- B. Incorrect Discuss
- 4. Cast iron has
Options- A. high compressive strength
- B. excellent machinability
- C. good casting characteristic
- D. all of these Discuss
- 5. The machine tool guide ways are usually hardened by
Options- A. vacuum hardening
- B. martempering
- C. induction hardening
- D. flame hardening Discuss
- 6. Phosphor bronze has
Options- A. high resistance to corrosion
- B. good wearing qualities and high elasticity
- C. valuable cold working property
- D. all of these Discuss
- 7. The temperature point at which the change ends on heating the steel is called
Options- A. lower critical point
- B. upper critical point
- C. point of recalescence
- D. point of decalescence Discuss
- 8. Thermosetting plastics are those materials which
Options- A. are formed into shape under heat and pressure and results in a permanently hard product
- B. do not become hard with the application of heat and pressure and no chemical change occurs
- C. are flexible and can withstand considerable wear under suitable conditions
- D. are used as a friction lining for clutches and brakes Discuss
- 9. The process used for relieving the internal stresses previously set up in the Metal and for increasing the machinability of steel, is
Options- A. normalising
- B. full annealing
- C. process annealing
- D. spheroidising Discuss
- 10. The malleability is the property of a material due to which it can be rolled or hammered into thin sheets.
Options- A. Agree
- B. Disagree Discuss
Engineering Materials problems
Search Results
Correct Answer: can be drawn into wires
Correct Answer: eutectoid steel
Correct Answer: Incorrect
Correct Answer: all of these
Correct Answer: flame hardening
Correct Answer: good wearing qualities and high elasticity
Correct Answer: upper critical point
Correct Answer: are formed into shape under heat and pressure and results in a permanently hard product
Correct Answer: process annealing
Correct Answer: Agree
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.