logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Engineering Materials See What Others Are Saying!
  • Question
  • In a unit cell of a body centred cubic space lattice, there are __________ atoms.


  • Options
  • A. six
  • B. nine
  • C. fourteen
  • D. seventeen

  • Correct Answer
  • nine 


  • More questions

    • 1. The flow in a pipe or channel is said to be non-uniform when

    • Options
    • A. the liquid particles at all sections have the same velocities
    • B. the liquid particles at different sections have different velocities
    • C. the quantity of liquid flowing per second is constant
    • D. each liquid particle has a definite path
    • Discuss
    • 2. In water tube boilers

    • Options
    • A. water passes through the tubes which are surrounded by flames and hot gases
    • B. the flames and hot gases pass through the tubes which are surrounded by water
    • C. forced circulation takes place
    • D. none of these
    • Discuss
    • 3. The cutting speed is maximum while machining __________ with a high speed steel tool.

    • Options
    • A. cast iron
    • B. mild steel
    • C. brass
    • D. aluminium
    • Discuss
    • 4. The lip clearance angle is the angle formed by the

    • Options
    • A. leading edge of the land with a plane having the axis of the drill
    • B. flank and a plane at right angles to the drill axis
    • C. chisel edge and the lip as viewed from the end of a drill
    • D. none of the above
    • Discuss
    • 5. The obtuse angle, included between the chisel edge and the lip as viewed from the end of a drill, is called

    • Options
    • A. helix or rake angle
    • B. point angle
    • C. chisel edge angle
    • D. lip clearance angle
    • Discuss
    • 6. The carbide tools operating at very low cutting speeds (below 30 m/min)

    • Options
    • A. reduces tool life
    • B. increases tool life
    • C. have no effect on tool life
    • D. spoils the work piece
    • Discuss
    • 7. Which of the following parameters govern the value of shear angle in continuous chip formation?

    • Options
    • A. True feed
    • B. Chip thickness
    • C. Rake angle of the cutting tool
    • D. all of these
    • Discuss
    • 8. If u1 and u2 are the velocities of two moving bodies in the same direction before impact and v1 and v2 are their velocities after impact, then coefficient of restitution is given by

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 9. The heat transfer by conduction through a thick sphere is given by

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 10. Nusselt number (NN) is given by

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment