Discussion
Home ‣ Mechanical Engineering ‣ Steam Boilers and Engines Comments
- Question
The draught in locomotive boilers is produced by a
Options- A. chimney
- B. centrifugal fan
- C. steam jet
- D. none of these
- Correct Answer
- steam jet
- 1. A valve installed between the boiler and the feed pump is
Options- A. blow off cock
- B. feed check valve
- C. steam stop valve
- D. none of these Discuss
- 2. A vessel into which the steam is exhausted and condensed after doing work in an engine cylinder or turbine is known as
Options- A. steam condenser
- B. steam boiler
- C. steam preheater
- D. economiser Discuss
- 3. In a steam condenser, the partial pressure of steam and air are 0.06 bar and 0.007 bar respectively. The condenser pressure is
Options- A. 0.007 bar
- B. 0.053 bar
- C. 0.06 bar
- D. 0.067 bar Discuss
- 4. The principal function of a stop valve is to
Options- A. control the flow of steam from the boiler to the main pipe and to shut off the steam completely when required
- B. empty the boiler when required and to discharge the mud, scale or sediments which are accumulated at the bottom of the boiler
- C. put off fire in the furnace of the boiler when the level of water in the boiler falls to an unsafe limit
- D. increase the temperature of saturated steam without raising its pressure Discuss
- 5. In surface condensers, the condensate and the cooling water mixes up.
Options- A. True
- B. False Discuss
- 6. The ratio of the energy required to produce the artificial draught (expressed in metres head or J/kg of flue gas) to the mechanical equivalent of extra heat carried away per kg of flue gases due to natural draught, is known as
Options- A. efficiency of the boiler
- B. efficiency of the chimney
- C. efficiency of the fan
- D. power of the boiler Discuss
- 7. Which of the following statement is correct?
Options- A. A horizontal steam engine requires less floor area than a vertical steam engine.
- B. The steam pressure in the cylinder is not allowed to fall below the atmospheric pressure.
- C. The compound steam engines are generally non-condensing steam engines.
- D. all of the above Discuss
- 8. A condenser maintains a low pressure (below atmospheric) so as to obtain the maximum possible energy from steam and thus to secure a high efficiency.
Options- A. Agree
- B. Disagree Discuss
- 9. The crown of the fire box is made hemispherical in order to resist intense heat in the fire box.
Options- A. True
- B. False Discuss
- 10. The indicated thermal efficiency is defined as the
Options- A. ratio of thermal efficiency to the Rankine efficiency
- B. ratio of brake power to the indicated power
- C. ratio of heat equivalent to indicated power to the energy supplied in steam
- D. product of thermal efficiency and Rankine efficiency Discuss
Steam Boilers and Engines problems
Search Results
Correct Answer: feed check valve
Correct Answer: steam condenser
Correct Answer: 0.067 bar
Correct Answer: control the flow of steam from the boiler to the main pipe and to shut off the steam completely when required
Correct Answer: False
Correct Answer: efficiency of the chimney
Correct Answer: The steam pressure in the cylinder is not allowed to fall below the atmospheric pressure.
Correct Answer: Agree
Correct Answer: True
Correct Answer: ratio of heat equivalent to indicated power to the energy supplied in steam
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.