logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Steam Boilers and Engines Comments

  • Question
  • The ratio of the actual vacuum to the ideal vacuum in a condenser is called


  • Options
  • A. condenser efficiency
  • B. vacuum efficiency
  • C. nozzle efficiency
  • D. boiler efficiency

  • Correct Answer
  • vacuum efficiency 


  • Steam Boilers and Engines problems


    Search Results


    • 1. For the same length of stroke and speed of crankshaft, the piston speed for a double acting steam engine is __________ the piston speed of single acting steam engine.

    • Options
    • A. equal to
    • B. twice
    • C. three times
    • D. four times
    • Discuss
    • 2. When the speed of the engine is controlled by means of a valve in a steam pipe, which regulates the pressure of steam entering the engine, then the governing is known as

    • Options
    • A. throttle governing
    • B. cut-off governing
    • C. by-pass governing
    • D. none of these
    • Discuss
    • 3. The diameter of superheated tubes in a locomotive boiler is

    • Options
    • A. 13 mm
    • B. 31 mm
    • C. 130 mm
    • D. 230 mm
    • Discuss
    • 4. Fire tube boilers are limited to a maximum working pressure of

    • Options
    • A. 0.17 MN/m2
    • B. 1.7 MN/m2
    • C. 17 MN/m2
    • D. 170 MN/m2
    • Discuss
    • 5. Which of the following is a fire tube boiler?

    • Options
    • A. Lansashire boiler
    • B. Babcock and Wilcox boiler
    • C. Yarrow boiler
    • D. none of these
    • Discuss
    • 6. The draught (in mm of water), for maximum discharge of flue gases through the chimney, is given by (where H = Height ot the chimney in metres, and T1 = Absolute temperature of air outside the chimney in K)

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 7. A receiver type compound engine, requires a lighter flywheel.

    • Options
    • A. Yes
    • B. No
    • Discuss
    • 8. The device attached to the steam chest for preventing explosions due to excessive internal pressure of steam is called

    • Options
    • A. safety valve
    • B. water level indicator
    • C. pressure gauge
    • D. fusible plug
    • Discuss
    • 9. The high steam and low water safety valve is not used in

    • Options
    • A. Cochran boiler
    • B. Cornish boiler
    • C. Lancashire boiler
    • D. Locomotive boiler
    • Discuss
    • 10. A device used to put off fire in the furnace of the boiler when the level of water in the boiler falls to an unsafe limit, is called

    • Options
    • A. blow off cock
    • B. stop valve
    • C. superheater
    • D. none of these
    • Discuss


    Comments

    There are no comments.

Enter a new Comment