logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Steam Boilers and Engines Comments

  • Question
  • Fire tube boilers are limited to a maximum working pressure of


  • Options
  • A. 0.17 MN/m2
  • B. 1.7 MN/m2
  • C. 17 MN/m2
  • D. 170 MN/m2

  • Correct Answer
  • 1.7 MN/m2 


  • Steam Boilers and Engines problems


    Search Results


    • 1. Which of the following is a fire tube boiler?

    • Options
    • A. Lansashire boiler
    • B. Babcock and Wilcox boiler
    • C. Yarrow boiler
    • D. none of these
    • Discuss
    • 2. The average value of diagram factor lies between

    • Options
    • A. 0.2 to 0.5
    • B. 0.5 to 0.65
    • C. 0.65 to 0.9
    • D. 0.8 to 1.2
    • Discuss
    • 3. By compounding the expansion of steam in two or more cylinders, the ratio of expansion

    • Options
    • A. does not change
    • B. increases
    • C. decreases
    • Discuss
    • 4. The amount of water evaporated in kg per kg of fuel burnt is called

    • Options
    • A. evaporative capacity of a boiler
    • B. equivalent evaporation from and at 100° C
    • C. boiler efficiency
    • D. none of these
    • Discuss
    • 5. In forced circulation steam boilers, the force is applied

    • Options
    • A. to draw water
    • B. to circulate water
    • C. to drain off the water
    • D. all of these
    • Discuss
    • 6. The diameter of superheated tubes in a locomotive boiler is

    • Options
    • A. 13 mm
    • B. 31 mm
    • C. 130 mm
    • D. 230 mm
    • Discuss
    • 7. When the speed of the engine is controlled by means of a valve in a steam pipe, which regulates the pressure of steam entering the engine, then the governing is known as

    • Options
    • A. throttle governing
    • B. cut-off governing
    • C. by-pass governing
    • D. none of these
    • Discuss
    • 8. For the same length of stroke and speed of crankshaft, the piston speed for a double acting steam engine is __________ the piston speed of single acting steam engine.

    • Options
    • A. equal to
    • B. twice
    • C. three times
    • D. four times
    • Discuss
    • 9. The ratio of the actual vacuum to the ideal vacuum in a condenser is called

    • Options
    • A. condenser efficiency
    • B. vacuum efficiency
    • C. nozzle efficiency
    • D. boiler efficiency
    • Discuss
    • 10. The draught (in mm of water), for maximum discharge of flue gases through the chimney, is given by (where H = Height ot the chimney in metres, and T1 = Absolute temperature of air outside the chimney in K)

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment