logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Steam Boilers and Engines See What Others Are Saying!
  • Question
  • Combustuion of fuel takes place __________ the engine cylinder of a steam engine.


  • Options
  • A. outside
  • B. inside

  • Correct Answer
  • outside 


  • More questions

    • 1. In centreless grinders, the maximum angular adjustment of the regulating wheel is

    • Options
    • A. 5°
    • B. 10°
    • C. 15°
    • D. 20°
    • Discuss
    • 2. The increase in depth of cut and feed rate __________ surface finish.

    • Options
    • A. improves
    • B. deteriorates
    • C. does not effect
    • Discuss
    • 3. A spherical body is symmetrical about its perpendicular axis. According to Routh's rule, the moment of inertia of a body about an axis passing through its centre of gravity is(where, M = Mass of the body, and S = Sum of the squares of the two semi-axes.)

    • Options
    • A. MS/3
    • B. MS/4
    • C. MS/5
    • D. none of these
    • Discuss
    • 4. A flow in which __________ force is dominating over the viscosity is called turbulent flow.

    • Options
    • A. elastic
    • B. surface tension
    • C. viscous
    • D. inertia
    • Discuss
    • 5. The ratio of maximum shear stress developed in a rectangular beam and a circular beam of the same cross-sectional area is

    • Options
    • A. 2/3
    • B. 3/4
    • C. 1
    • D. 9/8
    • Discuss
    • 6. The power absorbed (in watts) in overcoming the viscous resistance of a footstep bearing is

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 7. The time of flight of a projectile on downward inclined plane depends upon

    • Options
    • A. angle of projection
    • B. angle of inclination of the plane
    • C. both (a) and (b)
    • D. none of these
    • Discuss
    • 8. The flow in a pipe is turbulent when Reynold number is

    • Options
    • A. less than 2000
    • B. between 2000 and 2800
    • C. more than 2800
    • D. none of these
    • Discuss
    • 9. The operation of forcing additional air under pressure into the engine cylinder is known as

    • Options
    • A. supercharging
    • B. carburation
    • C. turbulence
    • D. delay period
    • Discuss
    • 10. In spot welding, the distance between the nearest edge of the plate and centre of weld should be equal to

    • Options
    • A. d
    • B. 1.5 d
    • C. 3 d
    • D. 6 d
    • Discuss


    Comments

    There are no comments.

Enter a new Comment