Discussion
Home ‣ Mechanical Engineering ‣ Steam Boilers and Engines Comments
- Question
In a receiver type compound engine, the high pressure and low pressure cylinders
Options- A. have common piston rod
- B. are set at 90°
- C. have separate piston rods
- D. are set in V - arrangement
- Correct Answer
- have separate piston rods
- 1. The actual vacuum in a condenser is equal to
Options- A. barometric pressure + actual pressure
- B. barometric pressure - actual pressure
- C. gauge pressure + atmospheric pressure
- D. gauge pressure - atmospheric pressure Discuss
- 2. The damper in a steam boiler is provided to control the draught (i.e. rate of flow of air) and thus regulate the rate of generation of steam.
Options- A. Correct
- B. Incorrect Discuss
- 3. The main object of a boiler trial is
Options- A. to determine the generating capacity of the boiler
- B. to determine the thermal efficiency of the boiler when working at a definite pressure
- C. to prepare heat balance sheet for the boiler
- D. all of the above Discuss
- 4. The shell of the Cochran boiler is made hemispherical
Options- A. to give maximum space and strength
- B. to withstand the pressure of steam inside the boiler
- C. both (a) and (b)
- D. none of the above Discuss
- 5. The clearance in the engine cylinder
Options- A. increases the mean effective pressure
- B. increases the workdone
- C. decreases the efficiency of the engine
- D. all of these Discuss
- 6. The cylinder condensation or missing quantity may be reduced by
Options- A. the efficient steam jacketing of the cylinder walls
- B. superheating the steam supplied to the engine cylinder
- C. keeping the expansion ratio small in each cylinder
- D. all of the above Discuss
- 7. Which of the following is not a boiler mounting?
Options- A. Blow off cock
- B. Feed check valve
- C. Economiser
- D. Fusible plug Discuss
- 8. The air pressure at the fuel bed is reduced below that of atmosphere by means of a fan placed at or near the bottom of the chimney to produce a draught. Such a draught is called
Options- A. natural draught
- B. induced draught
- C. forced draught
- D. balanced draught Discuss
- 9. The selection of type and size of a steam boiler depends upon
Options- A. the power required and working pressure
- B. the geographical position of the power house
- C. the fuel and water available
- D. all of the above Discuss
- 10. The mechanical draught __________ with the amount of smoke.
Options- A. increases
- B. decreases
- C. does not effect Discuss
Steam Boilers and Engines problems
Search Results
Correct Answer: barometric pressure - actual pressure
Correct Answer: Correct
Correct Answer: all of the above
Correct Answer: both (a) and (b)
Correct Answer: all of these
Correct Answer: all of the above
Correct Answer: Economiser
Correct Answer: induced draught
Correct Answer: all of the above
Correct Answer: decreases
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.