logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Steam Boilers and Engines Comments

  • Question
  • The high steam and low water safety valve is used to blow off steam when the


  • Options
  • A. steam pressure exceeds the working pressure
  • B. water level in the boiler becomes too low
  • C. both (a) and (b)
  • D. none of the above

  • Correct Answer
  • both (a) and (b) 


  • Steam Boilers and Engines problems


    Search Results


    • 1. The function of a superheater is to heat the feed water by utilising the heat in the exhaust flue gases before leaving through the chimney.

    • Options
    • A. Yes
    • B. No
    • Discuss
    • 2. When the expansion of steam is carried out in a single cylinder and then exhausted into the atmosphere or a condenser, the engine is said to be a simple steam engine.

    • Options
    • A. Correct
    • B. Incorrect
    • Discuss
    • 3. In a compound steam engine, the temperature range per cylinder is reduced, with corresponding reduction in the condensation.

    • Options
    • A. Correct
    • B. Incorrect
    • Discuss
    • 4. The water tubes in a Babcock and Wilcox boiler are

    • Options
    • A. vertical
    • B. horizontal
    • C. inclined
    • Discuss
    • 5. The equivalent evaporation is defined as

    • Options
    • A. the ratio of heat actually used in producing the steam to the heat liberated in the furnace
    • B. the amount of water evaporated or steam produced in kg per kg of fuel burnt
    • C. the amount of water evaporated from and at 100° C into dry and saturated steam
    • D. the evaporation of 15.653 kg of water per hour from and at 100° C
    • Discuss
    • 6. Willian's law holds good for throttle-governed engine, but not for cut-off governed engine.

    • Options
    • A. True
    • B. False
    • Discuss
    • 7. Willian's line follows the law (where b = A constant representing the shape of the Willian's line, a = Another constant i.e. no load consumption per hour, I.P. = Indicated power, and m = Steam consumption per hour)

    • Options
    • A. I.P. = a x m + b
    • B. m = a + b x I.P.
    • C. I.P. = b x m + a
    • D. m = b/I.P. - a
    • Discuss
    • 8. The water tube boilers produce steam at a __________ pressure than that of fire tube boilers.

    • Options
    • A. lower
    • B. higher
    • Discuss
    • 9. For the same diameter and thickness of tube, a water tube boiler has __________ heating surface as compared to fire tube boiler.

    • Options
    • A. more
    • B. less
    • C. equal
    • Discuss
    • 10. The missing quantity is mainly due to cylinder condensation and a small amount of steam leakage past the valves and piston.

    • Options
    • A. Agree
    • B. Disagree
    • Discuss


    Comments

    There are no comments.

Enter a new Comment