Discussion
Home ‣ Mechanical Engineering ‣ Hydraulic Machines Comments
- Question
The flow ratio of Francis turbine is defined as the ratio of the
Options- A. velocity of flow at inlet to the theoretical jet velocity
- B. theoretical velocity of jet to the velocity of flow at inlet
- C. velocity of runner at inlet to the velocity of flow at inlet
- D. none of the above
- Correct Answer
- velocity of flow at inlet to the theoretical jet velocity
- 1. The efficiency of jet propulsion for a ship with inlet orifices at right angles to the direction of motion of ship, will be maximum when the relative velocity of the jet and ship is equal to twice the velocity of the ship.
Options- A. Yes
- B. No Discuss
- 2. A Pelton wheel working under a constant head and discharge, has maximum efficiency when the speed ratio is
Options- A. 0.26
- B. 0.36
- C. 0, 46
- D. 0.56 Discuss
- 3. Which of the following pump is generally used to pump highly viscous fluid?
Options- A. Centrifugal pump
- B. Reciprocating pump
- C. Air lift pump
- D. Screw pump Discuss
- 4. The power developed by a turbine is (where H = Head of water under which the turbine is working)
Options- A. directly proportional to H1/2
- B. inversely proportional to H1/2
- C. directly proportional to H3/2
- D. inversely proportional to H3/2 Discuss
- 5. The working of which of the following hydraulic units is based on Pascal's law?
Options- A. Air lift pump
- B. Jet pump
- C. Hydraulic coupling
- D. Hydraulic press Discuss
- 6. A draft tube is used with impulse turbines.
Options- A. Yes
- B. No Discuss
- 7. The discharge through a reaction turbine __________ with the increase in unit speed.
Options- A. remains same
- B. increases
- C. decreases Discuss
- 8. Power required to drive a centrifugal pump is __________ proportional to N3.
Options- A. directly
- B. inversely Discuss
- 9. A jet of water enters and leaves a fixed curved vane tangentially. The force of jet along perpendicular to the vane is zero.
Options- A. True
- B. False Discuss
- 10. In a Francis turbine runner, the number of blades are generally between
Options- A. 2 to 4
- B. 4 to 8
- C. 8 to l6
- D. 16 to 24 Discuss
Hydraulic Machines problems
Search Results
Correct Answer: Yes
Correct Answer: 0, 46
Correct Answer: Screw pump
Correct Answer: directly proportional to H3/2
Correct Answer: Hydraulic press
Correct Answer: No
Correct Answer: decreases
Correct Answer: directly
Correct Answer: False
Correct Answer: 16 to 24
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.