Discussion
Home ‣ Mechanical Engineering ‣ Strength of Materials Comments
- Question
In case of eccentrically loaded struts __________ is preferred.
Options- A. solid section
- B. hollow section
- C. composite section
- D. reinforced section
- Correct Answer
- composite section
- 1. The shear force at the ends of a simply supported beam carrying a uniformly distributed load of w per unit length is
Options- A. zero at its both ends
- B. wl at one end and - wl at the other end
- C. wl/2 at one end and - wl/2 at the other end
- D. wl2/2 at one end and - wl2/2 at the other end Discuss
- 2. The bending moment of a cantilever beam of length l and carrying a uniformly distributed load of w per unit length is __________ at the free end.
Options- A. zero
- B. wl/4
- C. wl/2
- D. wl Discuss
- 3. Shear modulus is the ratio of
Options- A. linear stress to linear strain
- B. linear stress to lateral strain
- C. volumetric strain to linear strain
- D. shear stress to shear strain Discuss
- 4. The bending stress in abeam is __________ bending moment.
Options- A. equal to
- B. less than
- C. more than
- D. directly proportional to Discuss
- 5. The Rankine's formula holds good for
Options- A. short columns
- B. long columns
- C. both short and long columns
- D. weak columns Discuss
- 6. In leaf springs, the maximum bending stress developed in the plates is (where W = Load acting on the spring, l = Span of the spring, n = Number of plates, b = Width of plates, and t = Thickness of plates)
Options- A.
- B.
- C.
- D.
Discuss
- 7. The shear modulus of most materials with respect to the modulus of elasticity is
Options- A. equal to half
- B. less than half
- C. more than half
- D. none of these Discuss
- 8. The ultimate tensile stress for mild steel is __________ the ultimate compressive stress.
Options- A. equal to
- B. less than
- C. more than Discuss
- 9. In a watch, the spring is used to store strain energy. This energy is released
Options- A. to stop the watch
- B. to run the watch
- C. to change the time
- D. all of these Discuss
- 10. A rectangular beam of length l supported at its two ends carries a central point load W. The maximum deflection occurs
Options- A. at the ends
- B. at l/3 from both ends
- C. at the centre
- D. none of these Discuss
Strength of Materials problems
Search Results
Correct Answer: wl/2 at one end and - wl/2 at the other end
Correct Answer: zero
Correct Answer: shear stress to shear strain
Correct Answer: directly proportional to
Correct Answer: both short and long columns
Correct Answer:
Correct Answer: less than half
Correct Answer: more than
Correct Answer: to run the watch
Correct Answer: at the centre
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.