logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Strength of Materials Comments

  • Question
  • In the below figure, curve D represents mild steel.
    In the below figure, curve D represents mild steel. Yes No


  • Options
  • A. Yes
  • B. No

  • Correct Answer
  • Yes 


  • Strength of Materials problems


    Search Results


    • 1. The total strain energy stored in a body is called proof resilience.

    • Options
    • A. Agree
    • B. Disagree
    • Discuss
    • 2. A shear stress across a plane, is always accompanied by a balancing shear stress across the plane and normal to it.

    • Options
    • A. True
    • B. False
    • Discuss
    • 3. The bending moment diagram for a simply supported beam loaded in its centre is

    • Options
    • A. a right angled triangle
    • B. an issoscles triangle
    • C. an equilateral triangle
    • D. a rectangle
    • Discuss
    • 4. According to Unwin's formula, the relation between diameter of rivet hole (d) and thickness of plate (t) is given by (where d and t are in mm)

    • Options
    • A. d = t
    • B. d = 1.6 t
    • C. d = 2t
    • D. d = 6 t
    • Discuss
    • 5. Which of the following is a proper sequence?

    • Options
    • A. proportional limit, elastic limit, yielding, failure
    • B. elastic limit, proportional limit, yielding, failure
    • C. yielding, proportional limit, elastic limit, failure
    • D. none of the above
    • Discuss
    • 6. According to Euler's column theory, the crippling load of a column is given by p = ?2 EI/Cl2. In the Euler's formula, the value of C for a column with one end fixed and the other end hinged, is 1/2.

    • Options
    • A. True
    • B. False
    • Discuss
    • 7. The moment of resistance of a balanced reinforced concrete beam is based on the stresses in

    • Options
    • A. steel only
    • B. concrete only
    • C. steel and concrete both
    • D. none of these
    • Discuss
    • 8. The Rankine's constant for a mild steel column with both ends hinged is

    • Options
    • A. 1/750
    • B. 1/1600
    • C. 1/7500
    • D. 1/9000
    • Discuss
    • 9. The given figure shows the Mohr's circle of stress for two unequal and like principal stresses (?x and ?y) acting at a body across two mutually perpendicular planes. The tangential stress is given by

    • Options
    • A. OC
    • B. OP
    • C. OQ
    • D. PQ
    • Discuss
    • 10. Modulus of rigidity may be defined as the ratio of

    • Options
    • A. linear stress to lateral strain
    • B. lateral strain to linear strain
    • C. linear stress to linear strain
    • D. shear stress to shear strain
    • Discuss


    Comments

    There are no comments.

Enter a new Comment