logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Strength of Materials Comments

  • Question
  • A simply supported beam 'A' of length l, breadth b, and depth d carries a central point load W. Another beam 'B' has the same length and depth but its breadth is doubled. The deflection of beam 'B' will be __________ as compared to beam 'A'.


  • Options
  • A. one-fourth
  • B. one-half
  • C. double
  • D. four times

  • Correct Answer
  • one-half 


  • Strength of Materials problems


    Search Results


    • 1. A body is subjected to a direct tensile stress of 300 MPa in one plane accompanied by a simple shear stress of 200 MPa. The maximum normal stress will be

    • Options
    • A. -100 MPa
    • B. 250 MPa
    • C. 300 MPa
    • D. 400 MPa
    • Discuss
    • 2. Two closely coiled helical springs 'A' and 'B' are equal in all respects but the diameter of wire of spring 'A' is double that of spring 'B' The stiffness of spring 'B' will be __________ that of spring 'A'

    • Options
    • A. one-sixteenth
    • B. one-eighth
    • C. one-fourth
    • D. one-half
    • Discuss
    • 3. The length of a conical bar is l, diameter of base is d and weight per unit volume is w. It is fixea at its upper end and hanging freely. The elongation of the bar under the action of its own weight will be

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 4. When a load on the free end of a cantilever beam is increased, failure will occur

    • Options
    • A. at the free end
    • B. at the fixed end
    • C. in the middle of the beam
    • D. at a distance 2l/3 from free end
    • Discuss
    • 5. The ratio of linear stress to the linear strain is called

    • Options
    • A. modulus of rigidity
    • B. modulus of elasticity
    • C. bulk modulus
    • D. Poisson's ratio
    • Discuss
    • 6. A body is subjected to a direct tensile stress of 300 MPa in one plane accompanied by a simple shear stress of 200 MPa. The minimum normal stress will be

    • Options
    • A. -100 MPa
    • B. 250 MPa
    • C. 300 MPa
    • D. 400 MPa
    • Discuss
    • 7. When a rectangular beam is loaded longitudinally, the shear force develops on the top layer.

    • Options
    • A. Agree
    • B. Disagree
    • Discuss
    • 8. When a body is subjected to a direct tensile stress (?x) in one plane accompanied by a simple shear stress (?xy), the maximum shear stress is

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 9. In a simply supported beam carrying a uniformly distributed load w per unit length, the point of contraflexure

    • Options
    • A. lies in the centre of the beam
    • B. lies at the ends of the beam
    • C. depends upon the length of beam
    • D. does not exist
    • Discuss
    • 10. A riveted joint may fail by

    • Options
    • A. tearing of the plate at an edge
    • B. tearing of the plate across a row of rivets
    • C. shearing of rivets
    • D. any one of these
    • Discuss


    Comments

    There are no comments.

Enter a new Comment