Discussion
Home ‣ Mechanical Engineering ‣ Strength of Materials See What Others Are Saying!
- Question
Two closely coiled helical springs 'A' and 'B' are equal in all respects but the diameter of wire of spring 'A' is double that of spring 'B' The stiffness of spring 'B' will be __________ that of spring 'A'
Options- A. one-sixteenth
- B. one-eighth
- C. one-fourth
- D. one-half
- Correct Answer
- one-sixteenth
- 1. The clearance in the engine cylinder has no effect on the steam consumption.
Options- A. True
- B. False Discuss
- 2. The critical thickness of insulation for a sphere is
Options- A. k/h0
- B. 2k/h0
- C. h0/k
- D. h0/2k Discuss
- 3. The distance, between the point of projection and the point where the projectile strikes the ground, is known as range.
Options- A. Correct
- B. Incorrect Discuss
- 4. The total energy possessed by a system of moving bodies
Options- A. is constant at every instant
- B. varies from point to point
- C. is maximum in the start and minimum at the end
- D. is minimum in the start and maximum at the end Discuss
- 5. A fluid whose viscosity changes with the rate of deformation or shear strain is known as non-newtonian fluid.
Options- A. True
- B. False Discuss
- 6. In arc welding, the electric arc is produced between the work and the electrode by
Options- A. voltage
- B. flow of current
- C. contact resistance
- D. all of these Discuss
- 7. In a gas turbine, air is obtained from the atmosphere and compressed in an air compressor.
Options- A. True
- B. False Discuss
- 8. In electric resistance welding, pressure is applied just after the completion of current.
Options- A. True
- B. False Discuss
- 9. Mohr's circle is used to determine the stresses on an oblique section of a body subjected to
Options- A. direct tensile stress in one plane accompanied by a shear stress
- B. direct tensile stress in two mutually perpendicular directions
- C. direct tensile stress in two mutually perpendicular directions accompanied by a simple shear stress
- D. all of the above Discuss
- 10. The torque transmitted by a hollow shaft of outer diameter (D) and inner diameter (d) is
Options- A.
- B.
- C.
- D.
Discuss
More questions
Correct Answer: False
Correct Answer: 2k/h0
Correct Answer: Correct
Correct Answer: is constant at every instant
Correct Answer: True
Correct Answer: contact resistance
Correct Answer: True
Correct Answer: True
Correct Answer: all of the above
Correct Answer:
Comments
There are no comments.More in Mechanical Engineering:
Automobile EngineeringCompressors, Gas Dynamics and Gas TurbinesEngineering MaterialsEngineering MechanicsHeat Transfer, Refrigeration and Air ConditioningHydraulic MachinesHydraulics and Fluid MechanicsIC Engines and Nuclear Power PlantsIndustrial Engineering and Production ManagementMachine DesignProduction EngineeringSteam Boilers and EnginesSteam Nozzles and TurbinesStrength of MaterialsTheory of machinesThermodynamicsWorkshop TechnologyProgramming
Copyright ©CuriousTab. All rights reserved.