logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Strength of Materials Comments

  • Question
  • The Young's modulus of a material is 125 GPa and Poissons ratio is 0.25. The modulus of rigidity of me material is


  • Options
  • A. 30 GPa
  • B. 50 GPa
  • C. 80 GPa
  • D. 100 GPa

  • Correct Answer
  • 50 GPa 


  • Strength of Materials problems


    Search Results


    • 1. Two shafts 'A' and 'B' are made of same material. The shaft 'A' is of diameter D and shaft 'B' is of diameter D/2. The strength of shaft 'B' is __________ as that of shaft 'A'

    • Options
    • A. one-eighth
    • B. one-fourth
    • C. one-half
    • D. four times
    • Discuss
    • 2. The stress developed in the material without any permanent set is called

    • Options
    • A. elastic limit
    • B. yield stress
    • C. ultimate stress
    • D. breaking stress
    • Discuss
    • 3. When a body is subjected to two equal and opposite pulls, as a result of which the body tends to extend its length, the stress and strain induced is

    • Options
    • A. compressive stress, tensile strain
    • B. tensile stress, compressive strain
    • C. tensile stress, tensile strain
    • D. compressive stress, compressive strain
    • Discuss
    • 4. If the modulus of elasticity for a given material is twice its modulus of rigidity, then bulk modulus is equal to

    • Options
    • A. 2C
    • B. 3C
    • C.
    • D.
    • Discuss
    • 5. For riveting, the size of hole drilled in plates is __________ shank diameter of rivet.

    • Options
    • A. equal to
    • B. less than
    • C. greater than
    • Discuss
    • 6. The unit of Young's modulus is same as that of stress.

    • Options
    • A. True
    • B. False
    • Discuss
    • 7. Every direct stress is always accompanied by a strain in its own direction and an opposite kind of strain in every direction, at right angles to it. Such a strain is known as

    • Options
    • A. linear strain
    • B. lateral strain
    • C. volumetric strain
    • D. shear strain
    • Discuss
    • 8. The bending moment of a cantilever beam of length l and carrying a uniformly distributed load of w per unit length is __________ at the fixed end.

    • Options
    • A. wl/4
    • B. wl/2
    • C. wl
    • D. wl2/2
    • Discuss
    • 9. A continuous beam is one which is

    • Options
    • A. fixed at both ends
    • B. fixed at one end and free at the other end
    • C. supported on more than two supports
    • D. extending beyond the supports
    • Discuss
    • 10. In a beam of uniform strength, the bending stress developed is constant and is equal to the allowable stress at every section of the beam.

    • Options
    • A. True
    • B. False
    • Discuss


    Comments

    There are no comments.

Enter a new Comment