logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Strength of Materials Comments

  • Question
  • When a bar is subjected to a change of temperature and its deformation is prevented, the stress induced in the bar is


  • Options
  • A. tensile stress
  • B. compressive stress
  • C. shear stress
  • D. thermal stress

  • Correct Answer
  • thermal stress 


  • Strength of Materials problems


    Search Results


    • 1. The bending moment on a section is maximum where shear force is

    • Options
    • A. minimum
    • B. maximum
    • C. changing sign
    • D. zero
    • Discuss
    • 2. The relation between modulus of elasticity (E) and modulus of rigidity (C) is given by

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 3. A fixed beam is one which is fixed at __________ of its ends.

    • Options
    • A. one
    • B. both
    • Discuss
    • 4. For a given stress, the ratio of moment of resistance of a beam of square cross-section when placed with its two sides horizontal to the moment of resistance with its diagonal horizontal, is

    • Options
    • A. 1/2
    • B. 1
    • C. 1/2
    • D. 2
    • Discuss
    • 5. When a rectangular beam is loaded transversely, the maximum tensile stress is developed on the

    • Options
    • A. top layer
    • B. bottom layer
    • C. neutral axis
    • D. every cross-section
    • Discuss
    • 6. Whenever some external system of forces acts on a body, it undergoes some deformation. As the body undergoes some deformation, it sets up some resistance to the deformation. This resistance per unit area to deformation, is called

    • Options
    • A. strain
    • B. stress
    • C. pressure
    • D. modulus of elasticity
    • Discuss
    • 7. The layer at the centre of gravity of the beam as shown in the below figure, will be

    • Options
    • A. in tension
    • B. in compression
    • C. neither in tension nor in compression
    • Discuss
    • 8. A simply supported beam 'A' of length l, breadth b and depth d carries a central point load W. Another bream 'B' has the same length and breadth but its depth is doubled. The deflection of beam 'B' will be double as compared to beam 'A'.

    • Options
    • A. Correct
    • B. Incorrect
    • Discuss
    • 9. A body is subjected to a direct tensile stress (?) in one plane. The shear stress is maximum at a section inclined at __________ to the normal of the section.

    • Options
    • A. 45° and 90°
    • B. 45° and 135°
    • C. 60° and 150°
    • D. 30° and 135°
    • Discuss
    • 10. The strain energy stored in a hollow circular shaft of outer diameter (D) and inner diameter (d) subjected to shear stress is

    • Options
    • A. x Volume of shaft
    • B. x Volume of shaft
    • C. x Volume of shaft
    • D. x Volume of shaft
    • Discuss


    Comments

    There are no comments.

Enter a new Comment