Discussion
Home ‣ Mechanical Engineering ‣ Strength of Materials Comments
- Question
The maximum bending moment of a simply supported beam of span l and carrying a point load W at the centre of beam, is
Options- A. Wl/4
- B. Wl/2
- C. Wl
- D. Wl2/4
- Correct Answer
- Wl/4
- 1. A pressure vessel is said to be a thick shell, when
Options- A. it is made of thick sheets
- B. the internal pressure is very high
- C. the ratio of wall thickness of the vessel to its diameter is less than 1/10.
- D. the ratio of wall thickness of the vessel to its diameter is greater than 1/10. Discuss
- 2. In a tensile test, when the material is stressed beyond elastic limit, the tensile strain __________ as compared to the stress.
Options- A. decreases slowly
- B. increases slowly
- C. decreases more quickly
- D. increases more quickly Discuss
- 3. In the above question, the ratio of stiffness of spring 'B' to spring 'A' will be
Options- A. 2
- B. 4
- C. 6
- D. 8 Discuss
- 4. When a body is subjected to a direct tensile stress (?) in one plane, then normal stress on an oblique section of the body inclined at an angle ? to the normal of the section is
Options- A. ? cos ?
- B. ? cos2 ?
- C. ? sin ?
- D. ? sin2 ? Discuss
- 5. For biaxial stress, the planes of maximum shear are at right angles to each other and are inclined at 45° to the principal planes.
Options- A. True
- B. False Discuss
- 6. Within elastic limit, shear stress is __________ shear strain.
Options- A. equal to
- B. less than
- C. directly proportional to
- D. inversely proportional to Discuss
- 7. The planes, which carry no shear stress, are known as principal planes.
Options- A. True
- B. False Discuss
- 8. In the below figure, the plastic range occurs
Options- A. before point A
- B. beyond point A
- C. between points A and D
- D. between points D and E Discuss
- 9. The stiffness of a closely-coiled helical spring is __________ proportional to number of turns.
Options- A. directly
- B. inversely Discuss
- 10. The ratio of maximum shear stress developed in a rectangular beam and a circular beam of the same cross-sectional area is
Options- A. 2/3
- B. 3/4
- C. 1
- D. 9/8 Discuss
Strength of Materials problems
Search Results
Correct Answer: the ratio of wall thickness of the vessel to its diameter is greater than 1/10.
Correct Answer: increases more quickly
Correct Answer: 8
Correct Answer: ? cos2 ?
Correct Answer: True
Correct Answer: directly proportional to
Correct Answer: True
Correct Answer: beyond point A
Correct Answer: inversely
Correct Answer: 9/8
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.