logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Strength of Materials Comments

  • Question
  • The neutral axis of a transverse section of a beam passes through the centre of gravity of the section and is


  • Options
  • A. in the vertical plane
  • B. in the horizontal plane
  • C. in the same plane in which the beam bends
  • D. at right angle to the plane in which the beam bends

  • Correct Answer
  • at right angle to the plane in which the beam bends 


  • Strength of Materials problems


    Search Results


    • 1. When a body is subjected to a direct tensile stress (?) in one plane, then tangential or shear stress on an oblique section of the body inclined at an angle ? to the normal of the section is

    • Options
    • A. ? sin 2?
    • B. ? cos 2?
    • C. ?/2 sin 2?
    • D. ?/2 cos 2?
    • Discuss
    • 2. The values of equivalent length (L) and actual length (l) of a column for both ends hinged is the same

    • Options
    • A. Yes
    • B. No
    • Discuss
    • 3. The perpendicular distance between the centre lines of the successive rows, is called pitch.

    • Options
    • A. Agree
    • B. Disagree
    • Discuss
    • 4. A square beam and a circular beam have the same length, same allowable stress and the same bending moment. The ratio of weights of the square beam to the circular beam is

    • Options
    • A. 1/2
    • B. 1
    • C. 1/1.12
    • D. 1/2
    • Discuss
    • 5. The lower layer of the beam as shown in the below figure, will be

    • Options
    • A. in tension
    • B. in compression
    • C. neither in tension nor in compression
    • Discuss
    • 6. The distance between the centre of a rivet hole to the nearest edge of plate, is called

    • Options
    • A. margin
    • B. pitch
    • C. back pitch
    • D. diagonal pitch
    • Discuss
    • 7. The change in length due to a tensile or compressive force acting on a body is given by (where P = Tensile or compressive force acting on the body, l = Original length of the body, A = Cross-sectional area of the body, and E = Young's modulus for the material of the body)

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 8. A steel bar 2 m long, 20 mm wide and 10 mm thick is subjected to a pull of 2 kN. If the same bar is subjected to a push of 2 kN, the Poission's ratio of the bar in tension will be __________ the Poisson's ratio for the bar in compression.

    • Options
    • A. equal to
    • B. less than
    • C. greater than
    • Discuss
    • 9. A thin cylindrical shell of diameter (d), length (l) and thickness (t)is subjected to an internal pressure (p). The hoop stress in the shell is

    • Options
    • A. pd/t
    • B. pd/2t
    • C. pd/4t
    • D. pd/6t
    • Discuss
    • 10. For biaxial stress, the planes of maximum shear are at right angles to each other and are inclined at 45° to the principal planes.

    • Options
    • A. True
    • B. False
    • Discuss


    Comments

    There are no comments.

Enter a new Comment