logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Strength of Materials See What Others Are Saying!
  • Question
  • Modular ratio of the two materials is the ratio of


  • Options
  • A. linear stress to linear strain
  • B. shear stress to shear strain
  • C. their modulus of elasticities
  • D. their modulus of rigidities

  • Correct Answer
  • their modulus of elasticities 


  • More questions

    • 1. By fitting an air vessel to the reciprocating pump, there is always a saving of work done and subsequently saving of power.The saving in case of a double acting reciprocating pump is

    • Options
    • A. 39.2%
    • B. 48.8%
    • C. 84.8%
    • D. 88.4%
    • Discuss
    • 2. Power required (in watts) to drive a centrifugal pump is (where Hm = Manometric head in metres, w = Specific weight in N/m3, Q = Discharge of the pump in m3/s, and ?o = Overall efficiency of the pump)

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 3. In a __________ , both cutting and non-cutting operations are performed at one station of the press in every stroke of the ram.

    • Options
    • A. simple die
    • B. progressive die
    • C. combination die
    • D. compound die
    • Discuss
    • 4. When ? is absorptivity, ? is reflectivity and ? is transmittivity, then for a diathermanous body,

    • Options
    • A. ? = 1, ? = 0 and ? = 0
    • B. ? = 0, ? = 1 and ? = 0
    • C. ? = 0, ? = 0 and ? = 1
    • D. ? + ? = 1 and ? = 0
    • Discuss
    • 5. In a shell and tube heat exchanger, baffles are provided on the shell side to

    • Options
    • A. improve heat transfer
    • B. provide support for tubes
    • C. prevent stagnation of shell side fluid
    • D. all of these
    • Discuss
    • 6. If the cutting speed is increased, then the built-up-edge

    • Options
    • A. becomes longer
    • B. may or may not form
    • C. becomes smaller and finally does not form at all
    • D. has nothing to do with speed
    • Discuss
    • 7. The heat supplied to the gaS at constant volume is (where m = Mass of gas, cv = Specific heat at constant volume, cp = Specific heat at constant pressure, T2 - T1 = Rise in temperature, and R = Gas constant)

    • Options
    • A. mR(T2 - T1)
    • B. mcv(T2 - T1)
    • C. mcp(T2 - T1)
    • D. mcp(T2 + T1)
    • Discuss
    • 8. The springs in brakes and clutches are used to

    • Options
    • A. to apply forces
    • B. to measure forces
    • C. to store strain energy
    • D. to absorb shocks
    • Discuss
    • 9. The clearance, in a single stage, single acting reciprocating air compressor does not effect the workdone on the air and the power required for compressing the air.

    • Options
    • A. True
    • B. False
    • Discuss
    • 10. The extension of a circular bar tapering uniformly from diameter d1 at one end to diameter d2 at the other end, and subjected to an axial pull of P is given by

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment