logo

CuriousTab

CuriousTab

Discussion

Home ‣ Mechanical Engineering ‣ Strength of Materials Comments
  • Question

  • Poisson's ratio is the ratio of linear stein to the volumetric strain.


  • Options
  • A. True
  • B. False

  • Correct Answer
  • False 

    • Strength of Materials problems

    Search Results

    • 1. The relation between equivalent length (L) and actual length (l) of a column for both ends fixed is

    • Options
    • A. L = l/2
    • B. L = l/2
    • C. L = l
    • D. L = 2l
      • Discuss
    • 2. The maximum shear stress in a thin spherical shell subjected to an internal pressure (p) is zero.

    • Options
    • A. Yes
    • B. No
      • Discuss
    • 3. The equivalent length, of a given column with given end conditions, is the length of an equivalent column of the same material and cross-section with hinged ends, and having the value of crippling load equal to that of the given column.

    • Options
    • A. True
    • B. False
      • Discuss
    • 4. Transverse fillet welds are designed for

    • Options
    • A. tensile strength
    • B. compressive strength
    • C. shear strength
    • D. bending strength
      • Discuss
    • 5. The state of stress at a point in a loaded member is shown in the below figure. The magnitude of maximum shear stress is

    • Options
    • A. 10 MPa
    • B. 30 MPa
    • C. 50 MPa
    • D. 100 MPa
      • Discuss
    • 6. The shear force of a cantilever beam of length l carrying a uniformly distributed load of w per unit length is __________ at the fixed end.

    • Options
    • A. zero
    • B. wl/4
    • C. wl/2
    • D. wl
      • Discuss
    • 7. A localised compressive stress at the area of contact between two members is known as

    • Options
    • A. tensile stress
    • B. bending stress
    • C. crushing stress
    • D. shear stress
      • Discuss
    • 8. Modular ratio of the two materials is the ratio of

    • Options
    • A. linear stress to linear strain
    • B. shear stress to shear strain
    • C. their modulus of elasticities
    • D. their modulus of rigidities
      • Discuss
    • 9. A section of beam is said to be in pure bending, if it is subjected to

    • Options
    • A. constant bending moment and constant shear force
    • B. constant shear force and zero bending moment
    • C. constant bending moment and zero shear force
    • D. none of the above
      • Discuss
    • 10. The columns whose slenderness ratio is less than 80, are known as

    • Options
    • A. short columns
    • B. long columns
    • C. weak columns
    • D. medium columns
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.