logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Strength of Materials Comments

  • Question
  • A beam which is fixed at one end and free at the other is called


  • Options
  • A. simply supported beam
  • B. fixed beam
  • C. overhanging beam
  • D. cantilever beam

  • Correct Answer
  • cantilever beam 


  • Strength of Materials problems


    Search Results


    • 1. When a thin cvlindrical shell is subjected to an internal pressure, the volumetric strain is (where ?1 = Hoop strain, and ?2 = Longitudinal strain)

    • Options
    • A. 2?1 - ?2
    • B. 2?1 + ?2
    • C. 2?2 - ?1
    • D. 2?2 + ?1
    • Discuss
    • 2. The pull required to tear off the plate per pitch length is (where p = Pitch of rivets, t = Thickness of plates, and ?t, ? and ?c = Permissible tensile, shearing and crushing stresses respectively)

    • Options
    • A. (p - 2d)t x ?c
    • B. (p - d)t x ?
    • C. (p - d)t x ?t
    • D. (2p - d)t x ?t
    • Discuss
    • 3. In the below figure, __________ represents glass.

    • Options
    • A. curve A
    • B. curve B
    • C. curve C
    • D. curve D
    • Discuss
    • 4. A closely coiled helical spring is of mean diameter (D) and spring wire diameter (d). The spring index is the ratio of

    • Options
    • A. 1/d
    • B. 1/D
    • C. D/d
    • D. d/D
    • Discuss
    • 5. When a body is subjected to three mutually perpendicular stresses, of equal intensity, the ratio of direct stress to the corresponding volumetric strain is known as

    • Options
    • A. Young's modulus
    • B. modulus of rigidity
    • C. bulk modulus
    • D. Poisson's ratio
    • Discuss
    • 6. The maximum deflection of a fixed beam of length l carrying a total load W uniformly distributed over the whole length is

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 7. The maximum deflection of a cantilever beam of length l with a point load W at the free end is

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 8. In a simple bending theory, one of the assumption is that the plane sections before bending remain plane after bending. This assumption means that

    • Options
    • A. stress is uniform throughout the beam
    • B. strain is uniform throughout the beam
    • C. stress is proportional to the distance from the neutral axis
    • D. strain is proportional to the distance from the neutral axis
    • Discuss
    • 9. A thick cylindrical shell having ro and ri as outer and inner radii, is subjected to an internal pressure (p). The minimum tangential stress at the outer surface of the shell is

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 10. The maximum bending moment for a simply supported beam with a gradually varying load from zero at both ends and w per metre at the centre, lies at the centre of a beam.

    • Options
    • A. Agree
    • B. Disagree
    • Discuss


    Comments

    There are no comments.

Enter a new Comment