logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Strength of Materials Comments

  • Question
  • If the magnitude of direct stress and bending stress is equal, then there will be zero stress at one of the extreme ends of a column.


  • Options
  • A. Agree
  • B. Disagree

  • Correct Answer
  • Agree 


  • Strength of Materials problems


    Search Results


    • 1. A circular shaft fixed at, A has diameter D for half of its length and diameter D/2 over the other half, as shown in the below figure. If the rotation of B relative to A is 0.1 radian, the rotation of C relative to B will be

    • Options
    • A. 0.4 radian
    • B. 0.8 radian
    • C. 1.6 radian
    • D. 3.2 radian
    • Discuss
    • 2. The torsional rigidity of a shaft is given by

    • Options
    • A. T/J
    • B. T/?
    • C. T/r
    • D. T/G
    • Discuss
    • 3. The maximum shear stress is equal to the radius of Mohr's circle.

    • Options
    • A. Correct
    • B. Incorrect
    • Discuss
    • 4. When a bar of length l, width b and thickness t is subjected to a push of P, its

    • Options
    • A. length, width and thickness increases
    • B. length, width and thickness decreases
    • C. length increases, width and thickness decreases
    • D. length decreases, width and tickness increases
    • Discuss
    • 5. The ratio of shear modulus to the modulus of elasticity for a Poisson's ratio of 0.4 will be

    • Options
    • A. 5/7
    • B. 7/5
    • C. 5/14
    • D. 14/5
    • Discuss
    • 6. The unit of strain is

    • Options
    • A. N-mm
    • B. N/mm
    • C. mm
    • D. no unit
    • Discuss
    • 7. When a body is subjected to three mutually perpendicular stresses, of equal intensity, the ratio of direct stress to the corresponding volumetric strain is known as

    • Options
    • A. Young's modulus
    • B. modulus of rigidity
    • C. bulk modulus
    • D. Poisson's ratio
    • Discuss
    • 8. A closely coiled helical spring is of mean diameter (D) and spring wire diameter (d). The spring index is the ratio of

    • Options
    • A. 1/d
    • B. 1/D
    • C. D/d
    • D. d/D
    • Discuss
    • 9. In the below figure, __________ represents glass.

    • Options
    • A. curve A
    • B. curve B
    • C. curve C
    • D. curve D
    • Discuss
    • 10. The pull required to tear off the plate per pitch length is (where p = Pitch of rivets, t = Thickness of plates, and ?t, ? and ?c = Permissible tensile, shearing and crushing stresses respectively)

    • Options
    • A. (p - 2d)t x ?c
    • B. (p - d)t x ?
    • C. (p - d)t x ?t
    • D. (2p - d)t x ?t
    • Discuss


    Comments

    There are no comments.

Enter a new Comment