Discussion
Home ‣ Mechanical Engineering ‣ Strength of Materials Comments
- Question
According to Euler's column theory, the crippling load for a column length (l) hinged at both ends, is
Options- A.
- B.
- C.
- D.
- Correct Answer
-
- 1. A thin cylindrical shell of diameter (d), length (l) and thickness (t) is subjected to an internal pressure (p). The ratio of longitudinal strain to hoop strain is
Options- A.
- B.
- C.
- D.
Discuss
- 2. A beam encastered at both the ends is called
Options- A. simply supported beam
- B. fixed beam
- C. cantilever beam
- D. continuous beam Discuss
- 3. The direct stress, across a principal plane, is known as principal stress.
Options- A. Yes
- B. No Discuss
- 4. A pressure vessel is said to be a thin shell when it is made of thin sheets.
Options- A. Agree
- B. Disagree Discuss
- 5. In a riveted joint, when the rivets in the various rows are opposite to each other, the joint is said to be
Options- A. chain riveted
- B. zig-zag riveted
- C. diamond riveted
- D. none of these Discuss
- 6. The ratio of bulk modulus to Young's modulus for a Poisson's ratio of 0.25 will be
Options- A. 1/3
- B. 2/3
- C. 1
- D. 3/2 Discuss
- 7. When a column is subjected to an eccentric load, the stress induced in the column will be
Options- A. direct stress only
- B. bending stress only
- C. shear stress only
- D. direct and bending stress both Discuss
- 8. A double strap butt joint with equal straps is
Options- A. always in single shear
- B. always in double shear
- C. either in single shear or double shear
- D. none of these Discuss
- 9. A reinforced cement concrete beam is considered to be made of
Options- A. homogeneous material
- B. hetrogeneous material
- C. composite material
- D. isotropic material Discuss
- 10. Mohr's circle is used to determine the stresses on an oblique section of a body subjected to
Options- A. direct tensile stress in one plane accompanied by a shear stress
- B. direct tensile stress in two mutually perpendicular directions
- C. direct tensile stress in two mutually perpendicular directions accompanied by a simple shear stress
- D. all of the above Discuss
Strength of Materials problems
Search Results
Correct Answer:
Correct Answer: fixed beam
Correct Answer: Yes
Correct Answer: Disagree
Correct Answer: chain riveted
Correct Answer: 2/3
Correct Answer: direct and bending stress both
Correct Answer: always in double shear
Correct Answer: hetrogeneous material
Correct Answer: all of the above
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.