logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Strength of Materials Comments

  • Question
  • In the below figure, the point C represents
    In the below figure, the point C represents elastic limit upper yield point lower yield point breaki


  • Options
  • A. elastic limit
  • B. upper yield point
  • C. lower yield point
  • D. breaking point

  • Correct Answer
  • lower yield point 


  • Strength of Materials problems


    Search Results


    • 1. When a body is subjected to bi-axial stress i.e. direct stresses (?x) and (?y) in two mutually perpendicular planes accompanied by a simple shear stress (?xy), then minimum normal stress is

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 2. In order to avoid tearing off the plate at an edge, the distance from the centre of the rivet hole to the nearest edge of the plate (i.e. margin) should be (where d = Diameter of rivet hole in mm)

    • Options
    • A. d
    • B. 1.5 d
    • C. 2 d
    • D. 2.5 d
    • Discuss
    • 3. In a thick cylindrical shell subjected to an internal pressure (p), the tangential stress across the thickness of a cylinder is

    • Options
    • A. maximum at the outer surface and minimum at the inner surface
    • B. maximum at the inner surface and minimum at the outer surface
    • C. maximum at the outer surface and zero at the inner surface
    • D. maximum at the inner surface and zero at the outer surface
    • Discuss
    • 4. A simply supported beam is one which is supported on more than two supports.

    • Options
    • A. True
    • B. False
    • Discuss
    • 5. For long columns, thevalue of buckling load is __________ crushing load.

    • Options
    • A. equal to
    • B. less than
    • C. more than
    • Discuss
    • 6. In a riveted joint, when the rivets in the various rows are opposite to each other, the joint is said to be

    • Options
    • A. chain riveted
    • B. zig-zag riveted
    • C. diamond riveted
    • D. none of these
    • Discuss
    • 7. A pressure vessel is said to be a thin shell when it is made of thin sheets.

    • Options
    • A. Agree
    • B. Disagree
    • Discuss
    • 8. The direct stress, across a principal plane, is known as principal stress.

    • Options
    • A. Yes
    • B. No
    • Discuss
    • 9. A beam encastered at both the ends is called

    • Options
    • A. simply supported beam
    • B. fixed beam
    • C. cantilever beam
    • D. continuous beam
    • Discuss
    • 10. A thin cylindrical shell of diameter (d), length (l) and thickness (t) is subjected to an internal pressure (p). The ratio of longitudinal strain to hoop strain is

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment