logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Strength of Materials Comments

  • Question
  • A simply supported beam is one which is supported on more than two supports.


  • Options
  • A. True
  • B. False

  • Correct Answer
  • False 


  • Strength of Materials problems


    Search Results


    • 1. For long columns, thevalue of buckling load is __________ crushing load.

    • Options
    • A. equal to
    • B. less than
    • C. more than
    • Discuss
    • 2. The bending moment at the centre of a simply supported beam with a gradually varying load from zero at both ends to w per metre at the centre is wl/4.

    • Options
    • A. Yes
    • B. No
    • Discuss
    • 3. The extension of a circular bar tapering uniformly from diameter d1 at one end to diameter d2 at the other end, and subjected to an axial pull of P is given by

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 4. The horizontal thrust offered by the retaining wall on the retained material is (where w = Specific weight of the retained material, h = height of retaining wall, and (?) = Angle of repose of the retained earth)

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 5. When a body is subjected to bi-axial stress i.e. direct stresses (?x) and (?y) in two mutually perpendicular planes accompanied by a simple shear stress (?xy), then maximum normal stress is

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 6. In a thick cylindrical shell subjected to an internal pressure (p), the tangential stress across the thickness of a cylinder is

    • Options
    • A. maximum at the outer surface and minimum at the inner surface
    • B. maximum at the inner surface and minimum at the outer surface
    • C. maximum at the outer surface and zero at the inner surface
    • D. maximum at the inner surface and zero at the outer surface
    • Discuss
    • 7. In order to avoid tearing off the plate at an edge, the distance from the centre of the rivet hole to the nearest edge of the plate (i.e. margin) should be (where d = Diameter of rivet hole in mm)

    • Options
    • A. d
    • B. 1.5 d
    • C. 2 d
    • D. 2.5 d
    • Discuss
    • 8. When a body is subjected to bi-axial stress i.e. direct stresses (?x) and (?y) in two mutually perpendicular planes accompanied by a simple shear stress (?xy), then minimum normal stress is

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 9. In the below figure, the point C represents

    • Options
    • A. elastic limit
    • B. upper yield point
    • C. lower yield point
    • D. breaking point
    • Discuss
    • 10. In a riveted joint, when the rivets in the various rows are opposite to each other, the joint is said to be

    • Options
    • A. chain riveted
    • B. zig-zag riveted
    • C. diamond riveted
    • D. none of these
    • Discuss


    Comments

    There are no comments.

Enter a new Comment