logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Strength of Materials Comments

  • Question
  • The relation between Young's modulus (E), shear modulus (C) and bulk modulus (K) is given by


  • Options
  • A. The relation between Young's modulus (E), shear modulus (C) and bulk modulus (K) is given by
  • B. The relation between Young's modulus (E), shear modulus (C) and bulk modulus (K) is given by
  • C. The relation between Young's modulus (E), shear modulus (C) and bulk modulus (K) is given by
  • D. The relation between Young's modulus (E), shear modulus (C) and bulk modulus (K) is given by

  • Correct Answer
  •  


  • Strength of Materials problems


    Search Results


    • 1. In watches, the spring is used to absorb shocks and vibrations.

    • Options
    • A. Yes
    • B. No
    • Discuss
    • 2. The deformation of the bar per unit length in the direction of the force is known as

    • Options
    • A. linear strain
    • B. lateral strain
    • C. volumetric strain
    • D. shear strain
    • Discuss
    • 3. Parallel fillet welds are designed for bending strength.

    • Options
    • A. Agree
    • B. Disagree
    • Discuss
    • 4. When a beam is subjected to a bending moment, the strain in a layer is __________ the distance from the neutral axis.

    • Options
    • A. equal to
    • B. directly proportional to
    • C. inversely proportional to
    • D. independent of
    • Discuss
    • 5. A column of length (l) with both ends fixed may be considered as equivalent to a column of length __________ with both ends hinged.

    • Options
    • A. l/8
    • B. l/4
    • C. l/2
    • D. l
    • Discuss
    • 6. Which of the following statement is correct?

    • Options
    • A. A continuous beam has only two supports at the ends.
    • B. A uniformly distributed load spreads uniformly over the whole length of a beam.
    • C. The bending moment is maximum where shear force is maximum.
    • D. The maximum bending moment of a simply supported beam of length l with a central point load W is Wl/8.
    • Discuss
    • 7. A rod is enclosed centrally in a tube and the assembly is tightened by rigid washers. If the assembly is subjected to a compressive load, then

    • Options
    • A. rod is under compression
    • B. tube is under compression
    • C. both rod and tube are under compression
    • D. tube is under tension and rod is under compression
    • Discuss
    • 8. Modulus of resilience is the proof resilience per unit volume of a material.

    • Options
    • A. Correct
    • B. Incorrect
    • Discuss
    • 9. The product of the tangential force acting on the shaft and its distance from the axis of the shaft (i.e. radius of shaft) is known as

    • Options
    • A. bending moment
    • B. twisting moment
    • C. torsional rigidity
    • D. flexural rigidity
    • Discuss
    • 10. The polar moment of inertia of a solid circular shaft of diameter (D) is

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment