logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Strength of Materials Comments

  • Question
  • A shaft revolving at ? rad / s transmits torque (T) in N-m. The power developed is


  • Options
  • A. T.? watts
  • B. 2 ? T? watts
  • C. A shaft revolving at ? rad / s transmits torque (T) in N-m. The power developed is T.? watts 2 ? T? watts
  • D. A shaft revolving at ? rad / s transmits torque (T) in N-m. The power developed is T.? watts 2 ? T? watts

  • Correct Answer
  • T.? watts 


  • Strength of Materials problems


    Search Results


    • 1. Strain is equal to (where l = Original length, and ?l = Change in length)

    • Options
    • A. l/?l
    • B. ?l/l
    • C. l.?l
    • D. l + ?l
    • Discuss
    • 2. In the below figure, the point E represents the maximum stress.

    • Options
    • A. True
    • B. False
    • Discuss
    • 3. When a bar of length l, width b and thickness t is subjected to a pull of P, its

    • Options
    • A. length, width and thickness increases
    • B. length, width and thickness decreases
    • C. length increases, width and thickness decreases
    • D. length decreases, width and thickness increases
    • Discuss
    • 4. Which of the following statement is correct?

    • Options
    • A. The stress is the pressure per unit area.
    • B. The strain is expressed in mm.
    • C. Hook's law holds good upto the breaking point.
    • D. Stress is directly proportional to strain within elastic limit.
    • Discuss
    • 5. The volumetric strain is the ratio of the

    • Options
    • A. original thickness to the change in thickness
    • B. change in thickness to the original thickness
    • C. original volume to the change in volume
    • D. change in volume to the original volume
    • Discuss
    • 6. The unit of modulus of elasticity is same as those of

    • Options
    • A. stress, strain and pressure
    • B. stress, force and modulus of rigidity
    • C. strain, force and pressure
    • D. stress, pressure and modulus of rigidity
    • Discuss
    • 7. The pull required to crush the rivet per pitch length is

    • Options
    • A. p.t.?t
    • B. d.t.?c
    • C. ?/4 x d2 x ?t
    • D. ?/4 x d2 x ?c
    • Discuss
    • 8. The breaking stress is __________ the ultimate stress.

    • Options
    • A. equal to
    • B. less than
    • C. greater than
    • Discuss
    • 9. The design of thin cylindrical shells is based on

    • Options
    • A. hoop stress
    • B. longitudinal stress
    • C. arithmetic mean of the hoop and the longitudinal stress
    • D. geometric mean of the hoop and longitudinal stress
    • Discuss
    • 10. Which of the following statement is wrong?

    • Options
    • A. In the theory of simple bending, the assumption is that the plane sections before bending remains plane after bending.
    • B. In a beam subjected to bending moment, the strain is directly proportional to the distance from the neutral axis.
    • C. At the neutral axis of a beam, the bending stress is maximum.
    • D. The bending stress in a beam is inversely proportional to the section modulus.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment