logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Strength of Materials Comments

  • Question
  • In Mohr's circle, the centre of circle from Y-axis is taken as


  • Options
  • A. In Mohr's circle, the centre of circle from Y-axis is taken as
  • B. In Mohr's circle, the centre of circle from Y-axis is taken as
  • C. In Mohr's circle, the centre of circle from Y-axis is taken as
  • D. In Mohr's circle, the centre of circle from Y-axis is taken as

  • Correct Answer
  •  


  • Strength of Materials problems


    Search Results


    • 1. The shear force and bending moment are zero at the free end of a cantilever beam, if it carries a

    • Options
    • A. point load at the free end
    • B. point load at the middle of its length
    • C. uniformly distributed load over the whole length
    • D. none of the above
    • Discuss
    • 2. The maximum deflection of a fixed beam of length l carrying a central point load W is

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 3. The springs in brakes and clutches are used to

    • Options
    • A. to apply forces
    • B. to measure forces
    • C. to store strain energy
    • D. to absorb shocks
    • Discuss
    • 4. The thermal or temperature stress is a function of

    • Options
    • A. increase in temperature
    • B. modulus of elasticity
    • C. coefficient of linear expansion
    • D. all of these
    • Discuss
    • 5. When a circular bar tapering uniformly from diameter d1, at one end to diameter d2 at the other end, is subjected to an increase in temperature (t), then the thermal stress induced is (where ? = Coefficient of linear expansion, and E = Modulus of elasticity for the bar material)

    • Options
    • A.
    • B.
    • C.
    • D.
    • Discuss
    • 6. The shear force diagram fora cantilever beam of length l and carrying a gradually varying load from zero at free end and w per unit length at the fixed end is a

    • Options
    • A. horizontal straight line
    • B. vertical straight line
    • C. inclined line
    • D. parabolic curve
    • Discuss
    • 7. When a body is subjected to a direct tensile stress (?) in one plane, the maximum shear stress is __________ the maximum normal stress.

    • Options
    • A. equal to
    • B. one-half
    • C. two-third
    • D. twice
    • Discuss
    • 8. A bolt is made to pass through a tube and both of them are tightly fitted with the help of washers and nuts. If the nut is tightened, then

    • Options
    • A. bolt arid tube are under tension
    • B. bolt and tube are under compression
    • C. bolt is under compression and tube is under tension
    • D. bolt is Under tension and tube is under compression
    • Discuss
    • 9. The volumetric strain is the ratio of the

    • Options
    • A. original thickness to the change in thickness
    • B. change in thickness to the original thickness
    • C. original volume to the change in volume
    • D. change in volume to the original volume
    • Discuss
    • 10. Which of the following statement is correct?

    • Options
    • A. The stress is the pressure per unit area.
    • B. The strain is expressed in mm.
    • C. Hook's law holds good upto the breaking point.
    • D. Stress is directly proportional to strain within elastic limit.
    • Discuss


    Comments

    There are no comments.

Enter a new Comment