logo

CuriousTab

CuriousTab

Discussion


Home Mechanical Engineering Strength of Materials Comments

  • Question
  • In a beam where shear force changes sign, the bending moment will be


  • Options
  • A. zero
  • B. minimum
  • C. maximum
  • D. infinity

  • Correct Answer
  • maximum 


  • Strength of Materials problems


    Search Results


    • 1. A lap joint is always in __________ shear.

    • Options
    • A. single
    • B. double
    • Discuss
    • 2. If percentage reduction in area of a certain specimen made of material 'A' under tensile test is 60% and the percentage reduction in area of a specimen with same dimensions made of material 'B' is 40%, then

    • Options
    • A. the material A is more ductile than material B
    • B. the material B is more ductile than material A
    • C. the ductility of material A and B is equal
    • D. the material A is brittle and material B is ductile
    • Discuss
    • 3. The given figure shows the Mohr's circle of stress for two unequal and like principal stresses (?x and ?y) acting at a body across two mutually perpendicular planes. The normal stress on an oblique section making an angle ? with the minor principle plane is given by

    • Options
    • A. OC
    • B. OP
    • C. OQ
    • D. PQ
    • Discuss
    • 4. The strain energy stored in a spring, when subjected to maximum load, without suffering permanent distortion, is known as

    • Options
    • A. impact energy
    • B. proof resilience
    • C. proof stress
    • D. modulus of resilience
    • Discuss
    • 5. The bending moment in the centre of a simply supported beam carrying a uniformly distributed load of w per unit length is

    • Options
    • A. zero
    • B. wl2/2
    • C. wl2/4
    • D. wl2/8
    • Discuss
    • 6. When a thin cylindrical shell is subjected to an internal pressure, there will be

    • Options
    • A. a decrease in diameter and length of the shell
    • B. an increase in diameter and decrease in length of the shell
    • C. a decrease in diameter and increase in length of the shell
    • D. an increase in diameter and length of the shell
    • Discuss
    • 7. The rectangular beam 'A' has length l, width b and depth d. Another beam 'B' has the same length and width but depth is double that of 'A'. The elastic strength of beam B will be __________ as compared to beam A.

    • Options
    • A. same
    • B. double
    • C. four times
    • D. six times
    • Discuss
    • 8. The shear force at apoint on a beam is the algebraic __________ of all the forces on either side of the point.

    • Options
    • A. sum
    • B. difference
    • Discuss
    • 9. When the shear force diagram is a parabolic curve between two points, it indicates that there is a

    • Options
    • A. point load at the two points
    • B. no loading between the two points
    • C. uniformly distributed load between the two points
    • D. uniformly varying load between the two points
    • Discuss
    • 10. The bending moment of a cantilever beam of length l and carrying a gradually varying load from zero at free end and w per unit length at the fixed end is __________ at the fixed end.

    • Options
    • A. wl/2
    • B. wl
    • C. wl2/2
    • D. wl2/6
    • Discuss


    Comments

    There are no comments.

Enter a new Comment