Discussion
Home ‣ Mechanical Engineering ‣ Production Engineering Comments
- Question
A fine grained grinding wheel is used to grind
Options- A. hard and brittle materials
- B. soft and ductile materials
- C. hard and ductile materials
- D. soft and brittle materials
- Correct Answer
- hard and brittle materials
- 1. The cutting speed for drilling __________ with high speed steel drills is 24 to 45 m/min.
Options- A. mild steel
- B. copper
- C. aluminium
- D. brass Discuss
- 2. A bottoming tap has
Options- A. its end tapered for about three or four threads
- B. its end tapered for about eight or ten threads
- C. full threads for the whole of its length
- D. none of the above Discuss
- 3. The operation of reproduction of an outline of a template on a workpiece is called face milling.
Options- A. Yes
- B. No Discuss
- 4. The enlarging of an existing circular hole with a rotating single point tool is called
Options- A. boring
- B. drilling
- C. reaming
- D. internal turning Discuss
- 5. The cutting speed for counter-boring should be __________ that of drilling operation.
Options- A. equal to
- B. less than
- C. greater than Discuss
- 6. Hard and tough materials like cast iron should be turned at
Options- A. slow speed
- B. high speed
- C. any speed
- D. certain specific speed Discuss
- 7. Tumbler gears in lathe are used to
Options- A. reduce the spindle speed
- B. cut gears
- C. give desired direction of movement to the lathe carriage
- D. drill a workpiece Discuss
- 8. In the relation VTn = C, the value of n for high speed steel tools varies from 0.25 to 0.40.
Options- A. Agree
- B. Disagree Discuss
- 9. Negative rakes are used for
Options- A. carbide tools
- B. heavy loads
- C. harder materials
- D. all of these Discuss
- 10. In oblique cutting system, the cutting edge of the tool
Options- A. may clear the width of the workpiece
- B. may or may not clear the width of the workpiece
- C. may not clear the width of the workpiece
- D. should always clear the width of the workpiece Discuss
Production Engineering problems
Search Results
Correct Answer: mild steel
Correct Answer: full threads for the whole of its length
Correct Answer: No
Correct Answer: boring
Correct Answer: greater than
Correct Answer: slow speed
Correct Answer: give desired direction of movement to the lathe carriage
Correct Answer: Disagree
Correct Answer: all of these
Correct Answer: may not clear the width of the workpiece
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.