Discussion
Home ‣ Mechanical Engineering ‣ Production Engineering Comments
- Question
The cutting speed for counter-boring should be __________ that of drilling operation.
Options- A. equal to
- B. less than
- C. greater than
- Correct Answer
- greater than
- 1. The parameter which completely defines the chip formation in a metal cutting process is
Options- A. shear angle
- B. chip-tool contact length
- C. both (a) and (b)
- D. none of these Discuss
- 2. In drilling mild steel and brass, the point angle of a drill is 118°.
Options- A. True
- B. False Discuss
- 3. The advantage of a broaching operation is that
Options- A. rate of production is very high
- B. high accuracy and high class of surface finish is possible
- C. roughing and finishing cuts are completed in one pass of the tool
- D. all of the above Discuss
- 4. When the shear angle is small
Options- A. path of shear is short and chip is thin
- B. path of shear is large and chip is thick
- C. path of shear is short and chip is thick
- D. path of shear is large and chip is thin Discuss
- 5. The angle between the face and flank of the single point cutting tool is known as
Options- A. rake angle
- B. clearance angle
- C. lip angle
- D. point angle Discuss
- 6. The enlarging of an existing circular hole with a rotating single point tool is called
Options- A. boring
- B. drilling
- C. reaming
- D. internal turning Discuss
- 7. The operation of reproduction of an outline of a template on a workpiece is called face milling.
Options- A. Yes
- B. No Discuss
- 8. A bottoming tap has
Options- A. its end tapered for about three or four threads
- B. its end tapered for about eight or ten threads
- C. full threads for the whole of its length
- D. none of the above Discuss
- 9. The cutting speed for drilling __________ with high speed steel drills is 24 to 45 m/min.
Options- A. mild steel
- B. copper
- C. aluminium
- D. brass Discuss
- 10. A fine grained grinding wheel is used to grind
Options- A. hard and brittle materials
- B. soft and ductile materials
- C. hard and ductile materials
- D. soft and brittle materials Discuss
Production Engineering problems
Search Results
Correct Answer: both (a) and (b)
Correct Answer: True
Correct Answer: all of the above
Correct Answer: path of shear is large and chip is thick
Correct Answer: lip angle
Correct Answer: boring
Correct Answer: No
Correct Answer: full threads for the whole of its length
Correct Answer: mild steel
Correct Answer: hard and brittle materials
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.