Discussion
Home ‣ Mechanical Engineering ‣ Production Engineering Comments
- Question
The method of grinding used to produce internal cylindrical holes and tapers, is
Options- A. internal cylindrical grinding
- B. form grinding
- C. external cylindrical grinding
- D. surface grinding
- Correct Answer
- internal cylindrical grinding
- 1. The operation of making a cone-shaped enlargement of the end of a hole is known as
Options- A. counter-sinking
- B. counter-boring
- C. trepanning
- D. spot facing Discuss
- 2. In a shaper
Options- A. tool is stationary and work reciprocates
- B. work is stationary and tool reciprocates
- C. tool moves over stationary work
- D. tool moves over reciprocating work Discuss
- 3. In metal machining, the zone where the maximum heat is generated due to the plastic deformation of metal, is called
Options- A. friction zone
- B. work-tool contact zone
- C. shear zone
- D. none of these Discuss
- 4. The aluminium oxide abrasive is chiefly used for grinding
Options- A. high speed steel
- B. carbon steel
- C. wrought iron
- D. all of these Discuss
- 5. The tool life is __________ cutting speed.
Options- A. independent of
- B. dependant upon Discuss
- 6. For turning small taper on long workpiece, the suitable method is
Options- A. by a form tool
- B. by setting over the tail stock
- C. by a taper turning attachment
- D. by swivelling the compound rest Discuss
- 7. The shear velocity is the velocity of
Options- A. tool relative to the workpiece
- B. chip relative to the tool
- C. tool along the tool face
- D. none of these Discuss
- 8. In drilling bakellite and fibrous plastics, the point angle of a drill is
Options- A. 90°
- B. 118°
- C. 135°
- D. 150° Discuss
- 9. The vector sum of cutting velocity and chip velocity is __________ shear velocity.
Options- A. equal to
- B. less than
- C. more than Discuss
- 10. The angle between the lathe centres is
Options- A. 30°
- B. 45°
- C. 60°
- D. 90° Discuss
Production Engineering problems
Search Results
Correct Answer: counter-sinking
Correct Answer: work is stationary and tool reciprocates
Correct Answer: shear zone
Correct Answer: all of these
Correct Answer: dependant upon
Correct Answer: by setting over the tail stock
Correct Answer: none of these
Correct Answer: 90°
Correct Answer: equal to
Correct Answer: 60°
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.