Discussion
Home ‣ Mechanical Engineering ‣ Production Engineering Comments
- Question
In centreless grinders, the regulating wheel is inclined at
Options- A. 0° to 8°
- B. 9° to 15°
- C. 16° to 20°
- D. 21° to 25°
- Correct Answer
- 0° to 8°
- 1. In __________ operation, the chip thickness is minimum at the beginning of the cut and it reaches to the maximum when the cut terminates.
Options- A. conventional milling
- B. climb milling
- C. face milling
- D. end milling Discuss
- 2. The tail stock and the carriage of a lathe may be guided on same or different guideway.
Options- A. True
- B. False Discuss
- 3. Spot facing is an operation of smoothing and squaring the surface around a hole.
Options- A. True
- B. False Discuss
- 4. Ceramic cutting tools are
Options- A. made by cold pressing of aluminium oxide powder
- B. available in the form of tips
- C. brittle and have low bending strength
- D. all of these Discuss
- 5. Which of the following statement is correct about hot machining?
Options- A. It requires less power than machining metals at room temperature.
- B. The rate of tool wear is lower.
- C. It is used for machining high strength and high temperature resistant materials.
- D. all of the above Discuss
- 6. The average cutting speed for turning mild steel with a high speed steel tool is
Options- A. 15 to 19 m/min
- B. 25 to 31 m/min
- C. 60 to 90 m/min
- D. 90 to 120 m/min Discuss
- 7. A drill bit of 20 mm diameter rotating at 500 r.p.m. with a feed rate of 0.2 mm/revolution is used to drill a through-hole in a mild steel plate 20 mm thickness. The depth of cut in this drilling operation is
Options- A. 0.2 mm
- B. 10 mm
- C. 20 mm
- D. 100 mm Discuss
- 8. The taper on the lathe spindle is
Options- A. 1 in 10
- B. 1 in 15
- C. 1 in 20
- D. 1 in 30 Discuss
- 9. The tool life is __________ cutting speed.
Options- A. independent of
- B. dependant upon Discuss
- 10. The aluminium oxide abrasive is chiefly used for grinding
Options- A. high speed steel
- B. carbon steel
- C. wrought iron
- D. all of these Discuss
Production Engineering problems
Search Results
Correct Answer: conventional milling
Correct Answer: True
Correct Answer: True
Correct Answer: all of these
Correct Answer: all of the above
Correct Answer: 25 to 31 m/min
Correct Answer: 20 mm
Correct Answer: 1 in 20
Correct Answer: dependant upon
Correct Answer: all of these
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.