Discussion
Home ‣ Mechanical Engineering ‣ Production Engineering Comments
- Question
In order to achieve a specific surface finish in single point turning, the most important factor to be controlled is
Options- A. depth of cut
- B. cutting speed
- C. feed
- D. tool rake angle
- Correct Answer
- cutting speed
- 1. For harder alloy steel, the point angle of the drill is kept
Options- A. equal to 118°
- B. less than 118°
- C. more than 118°
- D. any one of these Discuss
- 2. In a milling operation, two side milling cutters are mounted with a desired distance between them so that both sides of a workpiece can be milled simultaneously. This set up is called
Options- A. gang milling
- B. straddle milling
- C. string milling
- D. side milling Discuss
- 3. Crack in grinding wheel is developed due to
Options- A. high temperature developed at the contact of the wheel face and work
- B. grinding hard work
- C. low speed of wheel
- D. high speed of wheel Discuss
- 4. Continuous chips with built up edge are formed during machining of
Options- A. brittle metals
- B. ductile metals
- C. hard metals
- D. soft metals Discuss
- 5. Surface grinding is done to produce
Options- A. tapered surface
- B. flat surface
- C. internal cylindrical holes
- D. all of these Discuss
- 6. A better machinable metal is one which gives
Options- A. lower chip-tool contact area and larger shear angle
- B. higher chip-tool contact area and smaller shear angle
- C. lower chip-tool contact area and smaller shear angle
- D. higher chip-tool contact area and larger shear angle Discuss
- 7. Which of the following statement is correct about hot machining?
Options- A. It requires less power than machining metals at room temperature.
- B. The rate of tool wear is lower.
- C. It is used for machining high strength and high temperature resistant materials.
- D. all of the above Discuss
- 8. Ceramic cutting tools are
Options- A. made by cold pressing of aluminium oxide powder
- B. available in the form of tips
- C. brittle and have low bending strength
- D. all of these Discuss
- 9. Spot facing is an operation of smoothing and squaring the surface around a hole.
Options- A. True
- B. False Discuss
- 10. The tail stock and the carriage of a lathe may be guided on same or different guideway.
Options- A. True
- B. False Discuss
Production Engineering problems
Search Results
Correct Answer: more than 118°
Correct Answer: straddle milling
Correct Answer: high speed of wheel
Correct Answer: ductile metals
Correct Answer: flat surface
Correct Answer: lower chip-tool contact area and larger shear angle
Correct Answer: all of the above
Correct Answer: all of these
Correct Answer: True
Correct Answer: True
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.