Discussion
Home ‣ Mechanical Engineering ‣ Production Engineering Comments
- Question
For machining a cast iron workpiece by a high speed steel tool, the average cutting speed is
Options- A. 10 m/min
- B. 15 m/min
- C. 22 m/min
- D. 30 m/min
- Correct Answer
- 22 m/min
- 1. The correct sequence of the following parameters in order of their maximum to minimum influence on tool life is
Options- A. feed rate, depth of cut, cutting speed
- B. depth of cut, cutting speed, feed rate
- C. cutting speed, feed rate, depth of cut
- D. feed rate, cutting speed, depth of cut Discuss
- 2. In an orthogonal cutting, the depth of cut is halved and the feed rate is double. If the chip thickness ratio is unaffected with the changed cutting conditions, the actual chip thickness will be
Options- A. doubled
- B. halved
- C. quadrupled
- D. unchanged Discuss
- 3. For turning internal tapers, the suitable method is
Options- A. by a form tool
- B. by setting over the tail stock
- C. by a taper turning attachment
- D. by swivelling the compound rest Discuss
- 4. Which of the following parameters govern the value of shear angle in continuous chip formation?
Options- A. True feed
- B. Chip thickness
- C. Rake angle of the cutting tool
- D. all of these Discuss
- 5. Tool life is measured by the
Options- A. number of pieces machined between tool sharpenings
- B. time the tool is in contact with the job
- C. volume of material removed between tool sharpenings
- D. all of the above Discuss
- 6. An open structure of a grinding wheel is denoted by the number 1 to 8.
Options- A. Correct
- B. Incorrect Discuss
- 7. Lathe bed is made of
Options- A. mild steel
- B. alloy steel
- C. pig iron
- D. chilled cast iron Discuss
- 8. The form grinding is used to grind gear teeth, threads, splined shafts and holes.
Options- A. Correct
- B. Incorrect Discuss
- 9. Surface grinding is done to produce
Options- A. tapered surface
- B. flat surface
- C. internal cylindrical holes
- D. all of these Discuss
- 10. Continuous chips with built up edge are formed during machining of
Options- A. brittle metals
- B. ductile metals
- C. hard metals
- D. soft metals Discuss
Production Engineering problems
Search Results
Correct Answer: cutting speed, feed rate, depth of cut
Correct Answer: doubled
Correct Answer: by a taper turning attachment
Correct Answer: all of these
Correct Answer: all of the above
Correct Answer: Incorrect
Correct Answer: chilled cast iron
Correct Answer: Correct
Correct Answer: flat surface
Correct Answer: ductile metals
Comments
There are no comments.More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.